Controls - PEUGEOT Satelis Owner's Manual

A
J
B
D
E
F
I
1
• Set the time by successive pushes on the control button.
Pressing the control button for more than 3 seconds will make
the first digit of the minutes flash.
• Change the minutes by successive pushes on the control
button.
Pressing the control button for more than 3 seconds will make
the second digit of the minutes flash.
• Change the minutes by successive pushes on the control
button.
• Press the control button for more than 3 seconds to confirm
the clock setting.
D. Fuel gauge.
Fuel reserve gauge.
When the fuel tank is full all the segments of the fuel gauge are
lit.
The fuel reserve gauge corresponds to the two last
segments (E) which show two reserve levels.
1st level: the first two segments flash.
2nd level: the last segment flashes.
When the tank is empty, all the segments are off and the
C
pump (F) flashes.
G. Engine temperature gauge
When the engine temperature is too high, all segments are
switched on and the last flashes.(H)
Safe mode will be activated. You are advised to switch off the
K
engine and check the level of coolant after it has cooled down..
You are advised to have the vehicle checked by an authorised
dealer.
I. Maintenance indicator
The maintenance indicator goes on 5000 kms after the last
reset.
H
You are advised to go to an authorised dealer to have the
G
vehicle serviced and the message on the maintenance
indicator erased.
J. Battery charge warning light
If the indicator light turns on when riding, you are advised to
have the vehicle checked by an authorised dealer. If the
indicator light comes on at idling speed, this is normal.
K. Outside temperature gauge
The temperature shown is that read on the front of the vehicle.
2
3
the vehicle is moving, even if the engine has stalled and stays
on for 7 seconds after the vehicle stops. The headlight stays
on for 3 seconds after the ignition is switched off with the
vehicle stopped.
4. Indicators switch
To indicate a change of direction, press the switch (4) :
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles

CONTROLS

1. Horn switch
2. Light flashing button
3. Dipped lights/Headlights
switch
A
The dipped lights/headlights
switch has 2 functions:
B
A. High beam
In the high beam position, both
4
dip beam and high beam are
on simultaneously. (except
for Compressor)
1
B. Dip beam
The headlight stays on while
• Either to the right.
• Or to the left.
To stop the indicators flashing, press the switch. (4)
5. Starter switch
6. Emergency stop button
D
6
This feature is used to stop
the engine in case of
E
emergency. This button must
not be used to switch off the
7 engine on a regular basis.
D. Engine off position
5
E. Start-up position
7.Hazard warning light switch
The hazard warning lights only work with the ignition key in the
"ON" position.
The hazard warning lights are switched off automatically 1 hour
after the ignition was switched off, to perserve the battery.
FR
GB
DE
IT
ES
NL
GR
SE
PT
FI
DK
7/16