Connections On The Back - JVC TK-C1481 Instructions Manual

CONNECTION/INSTALLATION

Connections on the back

Power supply
TK-C1480U and TK-C1480E (DC 12 V or 24 V)
+ -
1 2
SYNC IN VIDEO OUT
POWER
MEMO
• If thin cables are used (i.e. with a high resistance), a significant voltage drop will occur
when the unit is at its maximum power consumption. Either use a thick cable to restrict
the voltage drop at the camera side to below 10%, or place the power supply near to the
camera. If voltage drop occurs during operation, the performance will be unstable.
• Attach the cable conductors so that they do not come into contact with the drop prevention
wires.
• Do not allow input from both a DC 12 V and AC 24 V power supply at the same time.
• When using a DC 12 V power supply, ensure that the polarities of the cable are correct.
• The AC 24 V power supply should conform to the following:
TK-C1480U Class 2 only
TK-C1480E Isolated power supply only
TK-C1481EG (AC230V)
SYNC IN VIDEO OUT
POWER
E-16
+ - + -
TX TX RX RX AUX GND
A B C D
Y/C OUT
SEE INST-
RUCTION
MANUAL
Y/C OUT
SEE INST-
RUCTION
MANUAL
Connect the DC 12 V or the AC 24 V power
supply to the DC 12V/AC 24V terminals. To
prevent connection errors or a cable
disconnection, we recommend the use of lug
plates for the connections.
The following table shows the connection
distances and connection cables provided
that 2-conductor VVF cables (vinyl-insulated
vinyl sheath cables) are used.
Maximum extension
100 m 260 m 410 m 500 m
(reference)
Conductor 1.0∅mm 1.6∅mm 2.0∅mm 2.6∅mm
diameter and more and more and more and more
Power cable connect to the commercial
AC230V outlet
CAUTION:
When you use this camera, the socket-out-
let shall be installed near equipment so
as to disconnect easily.