Connecting Through Analogue Output - JVC KY-F550 Instruction Manual

2. Preparation Before Shooting (continued)

Connecting Through Analogue Output

Images taken by this unit can be output to monitor, colour video printer or other devices.
Monitor
[RGB, Y/C, SYNC OUT]
CP700DSA CP700DSA
PAPER FEED & CUT COPY
ALARM ALARM SHEET SHEET PAPER PAPER DATA DATA
POWER POWER
Colour Video Printer etc.
1.
Connect device such as the Colour Video Printer
to this unit's [RGB, Y/C, SYNC OUT] terminal.
2.
Set the switches located at the side of this unit.
● Setting Switch 2
Set this switch to [ON] (upper side) for Y/C
output.
Set this switch to [OFF] (lower side) for RGB
output.
● Setting Switch 3
Set this switch to [ON] (upper side) if sync sig-
nal is to be superimposed onto the Green (G)
channel of the video signal.
☞ Page 10 '9 Function Setting Switch'
Example: During RGB output
ON
OFF
Switch 2
3.
Switch on the power of this unit.
E-16
BNC CABLE
[VIDEO OUT]
Clamp filter
(accessories)
VC-451-2
R
MITSUBISHI MITSUBISHI
ONLINE
G/Y
B/C
OPEN OPEN
SYNC
VBS
1 2 3 4
Switch 3
'Connecting the
AA-P700
Power Supply'
(Page 18)
POWER
[DC IN]
AC Adapter
[REMOTE]
[TRIGGER]
Microscope
Adapter
Trigger Switch
Caution
● Perform this when the devices are off.
● Use the 1/3-inch, C mount adapter for the micro-
scope adapter.
Notes
● Connect a switch between PIN 2 (TRIG) and PIN
3 (GND) of the [TRIGGER] terminal. If this switch
is set to [ON], a trigger will freeze the input image
to the camera and capturing of images synchro-
nized with the trigger is possible.
● Ensure to attach the supplied clamp filter to the
cable connected to the Analog Signal Output
[RGB, Y/C, SYNC OUT] terminal in order to re-
duce unwanted electromagnetic emissions.
☞ Page 48
AC ADAPTER AA-P700 AC ADAPTER AA-P700
ON
AC IN
OFF
REMOTE
CONTROL
UNIT
RM-LP55
RM-LP57