Remote Control Unit - Panasonic PT-LC80U Operating Instructions Manual

Projector control panel
# $ % &
'

Remote control unit

'
POWER
)
+
AUTO
SETUP
-
/
FREEZE
VOLUME
1
# RGB INPUT indicator
(page 25)
This indicator shows whether a
signal is being input to the RGB
input connectors (RGB 1 IN/RGB
2 IN). When an input signal is
detected, the indicator
illuminates.
14-E
NGLISH
Menu
<Top>
operation
<on connector
panel:page 16>
(
*
) +,
(
INPUT
VIDEO RGB
*
MENU
,
ENTER
.
SHUTTER
0
STD
D.ZOOM
INDEX
WINDOW
2
PROJECTOR
$ LAMP indicator
(page 48)
This indicator illuminates when it
is time to replace the lamp unit. It
flashes if a circuit abnormality is
detected.
% TEMP indicator
(page 47)
This indicator illuminates if an
abnormally high temperature is
detected inside the projector or
around it. If the temperature rises
above a certain level, the power
supply will be turned off
automatically and the indicator
will illuminate or flash.
& Power indicator
(page 25)
This indicator illuminates red
when the MAIN POWER switch is
turned on (standby mode), and
illuminates green when the power
is turned on and a picture starts
to be projected.
' POWER button
(pages 22 and 24)
( Input select (INPUT, VIDEO,
RGB) buttons
(page 23)
) AUTO SETUP button
(pages 23 and 26)
If this button is pressed while a
picture is being projected, the
projection settings will be
adjusted automatically in
accordance with the signal being
input. In addition, the angle of tilt
of the projector will be
automatically detected and
adjusted in order to correct any
keystone distortion.
* MENU button
(pages 30 and 32)
This button is used to display the
menu screens. When a menu
screen is being displayed, this
button can be used to return to a
previous screen or to clear the
screen.
+ Arrow (F F G G I I and H H ) buttons
(page 32)
These buttons are used to select
and adjust items in the menu
screens.
, ENTER button
(page 32)
This button is used to accept and
to activate items selected in the
on-screen menus.
- FREEZE button
(page 27)
This button is used to
momentarily freeze projection so
that a still picture is displayed.
. SHUTTER button
(page 27)
This button is used to
momentarily turn off the picture
and sound.
/ VOLUME +/- buttons
(page 28)
These buttons are used to adjust
the volume of the sound output
from the projector's built-in
speaker. Refer to page 31 for
details on how to adjust the
volume using the buttons on the
projector control panel.
0 STD (standard) button
(page 33)
This button is used to reset the
projector adjustment values to the
factory default settings.
1 INDEX WINDOW button
(page 29)
This button can be used to split
the image projection area into a
still image and a moving image.
2 D.ZOOM +/- buttons
(page 28)
These buttons are used to
enlarge the projected image.
E -15
NGLISH