CALL US AT: 1800 338 002 (Aust) or 0800 339 258 (NZ). period. Technical Data Identify additional safety measures to protect the operator from the effects of DWE315-XE vibration such as: maintain the tool and the accessories, keep the hands warm, organisation of work patterns. Voltage...
SAVE ALL WARNINGS AND INSTRUCTIONS FOR 3) PERSONAL SAFETY a) Stay alert, watch what you are doing and use common sense when FUTURE REFERENCE operating a power tool. Do not use a power tool while you are tired or The term “power tool” in the warnings refers to your mains-operated (corded) power under the influence of drugs, alcohol or medication.
Extension Cords d) Store idle power tools out of the reach of children and do not allow persons unfamiliar with the power tool or these instructions to operate the CAUTION: Use only extension cords that are approved by the country’s Electrical power tool.
COMPONENTS (FIG. 1) • Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling, and other construction activities. Wear protective clothing and wash WARNING: Never modify the power tool or any part of it. Damage or personal exposed areas with soap and water. Allowing dust to get into your mouth, eyes, injury could result.
ASSEMBLY AND ADJUSTMENTS INSTALLING/REMOVING SANDING FIG. 5 SHEETS (FIG. 5) WARNING: To reduce the risk of serious personal injury, turn tool off and A diamond shaped platen uses a hook and loop disconnect tool from power source before making any adjustments or removing/ adhesion system to attach the sanding sheets.
Page 8
CUT GUIDE CAUTION: Read and follow all manufacturers' safety warnings for any accessories used with this tool. This feature allows you to more accurately track a marked cut line. 1. Insert the guide arm (G) as shown in figure 10 into the slots on the left and right CAUTION: To avoid injury, ensure adaptor and accessory are securely tightened.
Using the Dust Extraction Adaptor with NOTE: The dust extraction adaptor is available on selected model only. FIG. 15 Plunge Cutting Accessory (Fig. 15) FIG. 13 1. Attach the dust extraction adaptor. Refer to Attaching the Dust Extraction Adaptor. 2. Push dust extraction arm (R) into the lower aperture of the dust extraction adaptor (Q).
LED Worklight (Fig. 18) MAINTENANCE The LED worklight (B) will activate when the trigger is depressed. WARNING: To reduce the risk of serious personal injury, turn tool off and disconnect tool from power source before making any adjustments or removing/ FIG.
Troubleshooting Problem Possible Cause Possible Solution Unit will not start. Cord not plugged in. Plug tool into a working outlet. Circuit fuse is blown. Replace circuit fuse. (If the product repeatedly causes the circuit fuse to blow, discontinue use immediately and have it serviced at an authorized service center.) Circuit breaker is...