Normal Sounds; Operating Controls - Whirlpool Cabrio WTW6400S Technical Manual

EXTRA RINSE
An extra rinse can be used to aid in the removal
of detergent or bleach residue from garments.
This option provides an additional rinse with
the same water temperature as the first rinse.
This is the default rinse setting for the Whitest
Whites cycle.
PRESOAK
Use this option for set-in stains and soil that
need extra time for removal. Soaking in this
washer is different than in a conventional wash-
er. The washer sprays the load with water and
detergent for 4 minutes at extra-low spin speed
followed by a brief period of wash action at
the speed of the selected cycle. Then another
4 minutes of spraying and extra-low spinning
occurs. The wash action then pauses for the
detergent to work on the soils. The Presoak
feature is followed by the selected cycle. Using
Presoak will extend your wash cycle.
END OF CYCLE SIGNAL VOLUME
The End of Cycle Signal produces an audible
sound when the wash cycle is finished. This
signal is helpful when you are removing items
from the washer as soon as it stops. Select
Loud, Soft or Off.

OPERATING CONTROLS

START
Press START to start your washer after a cycle
has been selected. Be sure all desired Modi-
fiers and Options have been selected. The lid
must be closed for the washer to start.
PAUSE/CANCEL
Press PAUSE/CANCEL once to pause or stop
the washer at any time. Press PAUSE/CANCEL
once to unlock the lid and add a garment.
Press START to complete the cycle from where
it was stopped. Press PAUSE/CANCEL twice
to turn off the washer.
LID LOCK
When the Lid Lock status light glows, the washer
lid is locked.
NOTE: You must wait until the lid lock light
turns off before the lid can be opened.
POWER
Press POWER to turn the washer on or off. The
washer shuts off automatically after 5 minutes
following the completion of a cycle.

NORMAL SOUNDS

Your new washer may make sounds your old
one didn't. Because the sounds might be un-
familiar, you may be concerned about them.
These sounds are normal.
DURING WASHING
If you select the Deep Clean option, you will
hear a spin/spray noise at the start of the
cycle.
DURING DRAIN
If water is drained quickly from your washer
(depending on your installation), you may hear
air being pulled through the pump during the
end of draining.
DURING WASH AND SPIN
This washer does not have a transmission. The
motor provides direct drive for agitation and
spin. You will hear sounds that are different
from those of a conventional washer.
3-11