Location Requirements - Whirlpool Cabrio WTW6400S Technical Manual

LOCATION REQUIREMENTS

Selecting the proper location for your washer
improves performance and minimizes noise
and possible washer "walk."
The washer can be installed in a basement,
laundry room, closet, or recessed area. See
"Drain System," page 2-3.
IMPORTANT: Do not install or store the wash-
er where it will be exposed to the weather.
Proper installation is your responsibility.
You will need:
• A water heater set to deliver 120°F (49°C)
water to the washer.
• A grounded electrical outlet located with-
in 4 ft (1.2 m) of where the power cord is
attached to the back of the washer. See
"Electrical Requirements."
• Hot and cold water faucets located within
3 ft (90 cm) of the hot and cold water fill
valves, and water pressure of 20-100 psi
(138-690 kPa) for best performance.
• A level floor with a maximum slope of
1˝(2.5 cm) under entire washer. Install-
ing the washer on carpeting is not recom-
mended.
• A sturdy floor to support the washer
weight (washer, water and load) of 315 lbs
(143 kgs).
Do not store or operate your washer in tem-
peratures at or below 32°F (0°C). Some wa-
ter can remain in the washer and can cause
damage in low temperatures.
INSTALLATION SPACING FOR RECESSED
AREA AND CLOSET INSTALLATIONS
The following spacing dimensions are rec-
ommended for this washer. This washer has
been tested for installation with spacing of 0˝
(0 cm) clearance on the sides. Recommend-
ed spacing should be considered for the fol-
lowing reasons:
• Additional spacing should be considered
for ease of installation and servicing.
• Additional spacing should be considered
on all sides of the washer to reduce noise
transfer.
• For closet installation with a door, minimum
ventilation openings in the top and bottom
of the door are required. Louvered doors
with equivalent ventilation openings are
acceptable.
• Companion appliance spacing should also
be considered.
17"*
(43.2 cm)
1"
27-1/2" 1"
(2.5 cm)
(69.9 cm) (2.5 cm)
A
A. Front view
B. Side view
C. Closet door with vents
* Required spacing
2-2
14"* max.
2
48 in. *
(35.6 cm)
2
(310 cm )
2
24 in. *
2
(155 cm )
1"* 27"
5"*
(2.5 cm) (68.6 cm)
(12.7 cm)
C
B
3"*
(7.6 cm)
3"*
(7.6 cm)