JVC GC-A70 Instructions Manual page 18

1. Get the camera ready. (Refer to
2. Toggle the [MODE] button to select the Camera mode [
3. Turn the Normal / Macro
4. Frame your subject. You may use either the viewfinder or the 1.5" full color TFT LCD monitor (Toggle the [DISPLAY]/ Up
button to activate or deactivate it)
* We recommend, however, that the viewfinder be used as far as possible to extend battery time since the LCD is highly
power consumptive.
5. Press the shutter button fully down.
If the "QUICK VIEW" function has been set to ON, the image captured will appear on the LCD monitor for a few seconds.
6. To continue capturing, repeat the above steps 4 & 5.
Notes:
To adjust the Image Quality and Resolution, please refer to
When the storage memory is full, you may either
The number of remaining shots
picture quality and memory size.
The actual number of remaining shots also differ depending on the shooting conditions. Hence, a single shot may reduce the
value by two or not change the value at all. This is not a malfunction of the LCD monitor. Also, upon the camera being turned
on, memory adjustments are made and the indicated remaining value may actually be higher than when the camera was last
turned off.
When you take pictures in bright locations or in clear fine weather, lines may appear on the monitor. This is not a malfunction.
Press the shutter button down steadily.
When the Status Indicator is lit, shooting/replay is not possible. Wait until the light goes off.
Never open the Battery/Memory card compartment door when the Status Indicator is lit for this may cause malfunction.
Please format new Memory cards with this camera before using them.
We recommend that you take some test shots to get accustomed to the camera before you actually start.
We cannot bear any responsibility for an inability to record or replay material normally, in the event of a problem with this
camera.
Store backups of important images in eg. your personal computer. We cannot bear any responsibility for any loss or alteration
to the images stored in the camera's internal or external memory.
It is prohibited to use images taken with this camera for commercial purposes without the consent of the copyright owner.
"Getting Started")
switch dial to Normal .
erase the images
shown on the LCD monitor is an approximate value based on the currently set resolution,
].
"Setting the Image Resolution and
that are no more required, or
Quality".
insert a new memory card.