JVC GC-A70 Instructions Manual page 13

1. Thread the thinner looped end of the strap through the strap holder.
2. Insert the other end of the strap through the thin loop and pull it all the way out. Ensure that the strap is securely
tightened unto the camera.
Note:
Be careful not to bump the camera or entangle the strap.
Inserting and Removing the SD / Multimedia Card
This camera can be used with either an SD card or a Multimedia card (MMC).
When traveling and capturing a lot of images, it is convenient to make use of an SD or a Multimedia card. When a card is
inserted into the camera, still images/video clips captured will be stored in the card's memory.
When the card is removed, the camera's internal memory will be used as the storage media.
Inserting the Memory Card
1. Turn off the camera's power by pressing the [POWER] button.
2. Open the Battery/Memory card compartment door.
3. Firmly insert the memory card into the memory card slot as far as it can go,
with the memory card electrodes (metal contacts) end facing the camera.
(Refer to the right figure.)
4. Close back the door firmly.
Removing the Memory Card
1. Turn off the camera's power by pressing the [POWER] button.
2. Open the Battery/Memory card compartment door.
3. Push the memory card in as far as it can go and release. The card will
spring back and protrude slightly. Pull it out with your fingers.
4. Close back the door firmly.
Notes:
SD and Multimedia cards are purchased separately.
Pay attention to the card direction when inserting. Wrong direction and forced insert can break it.
When the memory card is inserted, access to the camera's internal memory is not possible.
Cards available in the market, and those already formatted for PC and other devices may not be identified by this
camera. Therefore, before using them, it is necessary to
While the power of the camera is on, do not open the battery cover to replace the memory card or batteries as this
may cause irrecoverable corruption of card data.
The memory card is a sensitive device so it should not be subject to any shock. Do not touch the metal part of the
card with your hand.
When the memory card is write-protected, it cannot be used (A message "WRITE PROTECT" will appear on the LCD
monitor). You have to disable the write-protection first.
Switching the Power ON / OFF
Press the [POWER] button to toggle ON / OFF.
The Status Indicator will lit up immediately upon power on. The light will
go off after a while (the length of time varies with the capacity of the
memory card that is inserted in the camera) and the camera will then
be ready for use.
format them first with this camera.