Dometic A552 Service Manual page 19

- Reinstall thermostat case onto the new thermostat, secure with nut. During
assembly make sure that the navigation-securing pin of thermostat fits into
the bore of plate.
Figure 84
- Reinsert thermostat onto panel, secure with screws.
- Reassemble thermostat wires.
- Reinsert thermostat cover, secure.
- Insert thermostat capillary into cabinet approx. 200 mm deep. (Fig. 87)
Figure 87
- Place refrigerator in upright position.
- Insert thermostat capillary into cooling flange approx. 200 mm deep.
- Reinsert cooling flange, carefully positioning thermostat capillary, then
secure with 4 plate screws (the original corrosion-proof screws should be
used).
- Push thermostat switch back onto the shaft of thermostat. When
positioning, make sure that the shaft jointing fits with the switch bore
jointing. (Fig. 88)
Figure 88
(Fig. 86)
Figure 85
19
Figure 86