Capture Modes - Moultrie D-333 Instructions Manual

IV

CAPTURE MODES

1 MOTION DETECT
Still photos or videos are taken when an animal is detected. The number of photos taken per
detection event and whether still photos or videos are taken is configurable in settings. Photos
and videos are stored in the DCIM/100MFCAM folder on the SD card.
2 TIME LAPSE
The camera takes photos at specified interval(s) during the day. Time lapse mode can be set with up
to two (2) programs and configurable start and stop times for each program. During the set program
interval(s), the camera will take photos regularly based on the time lapse interval setting. The photos
are stored in the DCIM/100MFCAM folder on the SD card.
NOTE: See the section Setting Time Lapse Features for more information on setting up
Time Lapse Mode.
3 HYBRID
The camera operates in Time Lapse Mode during the programmed intervals and Motion Detect Mode
for the remainder of the day.
V
SETUP AND PROGRAMMING
m o t i o n p h 5 M I N
0 0 0 0 / 0 0 0 0 9 9 B 9 9 %
When the camera's power is turned ON, Auto will show on the top left corner of the LCD Display.
At this time, the picture count and the estimated battery life will also be displayed. If no buttons are
pressed within 10 seconds the LCD screen will enter sleep mode to conserve battery life. It will then
enter PIR detection Motion Detect mode and activate when motion is detected. To wake the camera
manually, press and hold the menu button until you see the default screen on the display.
s e t u p s e l e c t i o n
g e n e r a l
Setup Selection Setting
After the camera is turned ON the LCD display will indicate the default screen. Press the Menu
button and the Setup Selection screen will appear. Press the OK button, the selection will
start to flash. Press the Up/Down buttons to change the settings. Press the OK button again
to Iock in selection. Press the Right or Left buttons to move to the next setting. Using this method
you can customize your camera's feature settings.
Page 4
D-333 Digital Game Camera
IX
VIEWING TIME LAPSE
This easy-to-use software allows you to advance through the series of images a number of different ways:
BEGIN/END
Goes to the first or last photo in the Plot File.
FRAME BY FRAME SEARCH
Individually step forward or backward through each photo.
REWIND/PAUSE/PLAY
Play photos in sequence, pause, or play the photos in reverse order.
These functions simulate a video and are useful for manually searching
changes in the photos. When a sequence is being played, press
fast-forward or fast-rewind multiple times to increase speed. (1x-5x)
SEARCH
This function allows quick scanning of images foreword and back. The
scan pauses when the software detects a change in pixel content from
the last photo viewed. We detect change based on averages so it
will not be as accurate as a manual frame by frame search.
SEARCH REGION
Click on Set Search Region Button.
This allows you to define a specific search
area, rather than the whole photo. Drag the
red outline to the area you want to search.
This allows you to focus on a very precise area
if required.
SEARCH STEPS
This allows for even faster scans by skipping
the selected amount of images (1-50). The
higher this setting, the lower the search
results as it is ignoring selected photos. You
may find this option helpful if you have a
very large quantity of photos to scan.
Click OK.
Click on Motion Search Advance button.
Time Lapse Software
Page 13