Table of Contents
Advertisement
STEP 1 : Connect aerial cables
Insert an aerial plug tightly into the aerial socket on the back of the
TV set.
ANT.75
For all aerial problems please consult your local dealer.
The connection to the peripheral AV equipment, refer to section
"USING AV EQUIPMENT" on page 10, 11.
STEP 2 : Install batteries
1
Remove the battery cover
by sliding it in direction of
the arrow.
2
Install two "AAA/R03" 1.5
volt batteries so that the
"+" and "-" marks on the
batteries match the "+"
and "-" marks inside the
unit.
3
Close the battery cover.
Replace the batteries when the TV set is showing the following
symptoms: Operation is unsteady or erratic, sometimes the TV
does not work with the transmitter. Discharged batteries may leak
and damage the unit. The normal life of batteries should be from
nine to ten months.
Bij dit produkt zijn
batterijen geleverd.
Wanneer deze leeg zijn,
moet u ze niet
weggooien maar
inleveren als KCA.
STEP 3 : Connect AC Cord
The TV set is prepared for a mains voltage AC220~240V, 50Hz.
Connect the power cord of the TV set to a wall outlet. When the TV
set is not to be used for an extended period of time, it is advisable to
disconnect the power cord from the power outlet.
WARNING!
High voltages are used in the operation of this
set. Refer service to qualified service personnel.
4
INST
ALLA
TION
INST
ALLA
TION
This TV set provides a self-automatic tuning function called
"Plug & Play". The first time you switch on this TV set, it will
automatically begin to search and store all available channels.
To ensure that this feature works properly please follow the
steps below before you switch on the TV set.
Please make sure that your aerial cable is connected to the aerial
socket of the TV set before switching on.
Plug the Mains cable plug into a wall socket.
This TV set is prepared for a mains voltage of AC220~240V 50Hz.
1
You are now ready to switch on. Simply press the Mains
ON/OFF switch on the front of the TV set.
A red power indicator will appear.
The first page of "ATS euro plus" appears.
If no picture appears but the power indicator is on, press the
P
, P
standby mode.
Select country and Language
2
Select the country using the
P.MODE/OK button.
The next page appears for selecting your display language.
3
Select the language identification letter by using the
or
After you have selected a language, all messages and information
which subsequently appear on the screen will be in this language.
The ATS euro plus system will start as follows: The tuning status
and welcome messages will appear on the screen.
STEP 4: Turn Mains switch-on
, P , P
or 0 - 9 button as the TV set is in the
,
or
COUNTRY
A
B
CH
D
DK E
F
I
N
NL
P
S
SF
OTHERS
SELECT :
OK
EXIT : MENU
button. Press the P.MODE/OK button.
LANGUAGE
D
DK
E
F
I
NL
P
S
SELECT :
OK
EXIT : MENU
Thank you for purchasing your
JVC TV.
Now I am searching and storing all
programmes.
Please wait .
POS.
2
CH
C 5
,
or
button. Press the
GB
,
or
GB
SF
Advertisement
Table of Contents
