Baffle & Brick Replacement - Quadra-Fire SANTA FE Owner's Manual

R
F. Baffle & Brick Replacement
1. Place right brick in behind the right bracket and then
slide to the left so the tabs are behind the center brick.
Figure 20.1.
2. The brick will be flush against the back wall and the
braket's notches will be exposed. Figure 20.2.
3. Pull the right edge of the brick forward and slide the
brick into the notches both top and bottom of right
bracket. Figure 20.3.
4. Repeat for left brick.
5. Insert baffle into top front of firebox and then raise up
the bottom end and insert baffle tab into notch on the
right bracket to lock into place. Figure 20.5. Place the
left side hook of the bottom baffle over the top of brick
for stability.
6. The baffle does not completely cover the top of the
firebox. There is an opening as shown in Figure 20.6.
Figure 20.1
Brick is flush against back wall
Figure 20.2
Page 20
Do not remove rope
from center brick
Tabs
Brick in
front of
clip and
Notches
exposed
Lift Brick, pull forward at an angle
and drop down into notches
Figure 20.3
Figure 20.4
Figure 20.5
Opening at left side of Baffle
Figure 20.6
7068-114B
Santa Fe NZ Pellet Stove
Right Brick Installed
Insert Baffle Tab into Slot
December 1, 2011