Morphy Richards 2 slice hardware toaster Instructions page 3

Before first use
Before using the appliance for the
first time operate the toaster
without bread in a ventilated room.
The bread carriage levers ¤ will not
•
stay down unless the toaster is
connected to the mains supply.
• As with all new electric heating
elements, your toaster emits a
'new' smell when it is first switched
on which is quite normal.
Toasting
1 Select the desired level of browning
on the browning control fl marked
1 to 9. The setting required will vary
according to the moisture content
and thickness of the bread.
2 After selecting the desired level,
place your bread in the slots ⁄ and
depress the bread carriage lever
downwards until it locks.
3 After the set time has been reached
the bread will pop up automatically
ready for removal from the slots.
The bread carriage lever will have
returned to its upper position and
the heating element will have
switched off.
• If the bread in your toaster
becomes jammed disconnect your
toaster at the socket, allow it to
cool, then remove the bread.
• When not in use, remove the plug
from the mains socket.
• Allow the toaster to cool fully before
putting away.
WARNING: Do not wrap the
cable around the main body of
the appliance during or after
use.
Using the frozen button
B
To toast frozen bread do not adjust
the browning control from your
normal preferred setting, place the
bread normally in the bread slots,
then depress the relevant bread
carriage lever and press the frozen
button‹.
4
Using the re-heat button
If your toast has popped up and
gone cold, the toaster offers a re-
heat facility. To use, depress the
relevant bread carriage lever and
press the re-heat button ›
immediately. The button will
illuminate and the toaster will
operate for a short period re-
heating the bread.
Using the cancel button
If you wish to interrupt the toasting
process, press the cancel button
fi.
Hints & tips for perfect
toasting
• For best results ensure the bread
slices are of even thickness,
freshness and size.
• Stale bread toasts more rapidly
than fresh bread. Therefore, the
browning control should be set at a
lower setting than usual.
• Thin bread toasts quicker than
thick.
• In order to achieve uniform
browning, we recommend you wait a
minimum of 30 seconds between
each toasting so that the control
automatically resets.
• If toasting one slice only, you may
need to adjust the browning control
to a slightly lower setting.
• You may notice a slight variation in
toast colour on one side of a single
slice.
• All sorts of bread can be used as
well as teacakes, small rolls etc.
Slices should not however be so
thick as to cause burning or
jamming within the bread slots.
• When toasting more than one slice it
is recommended they are of equal
size and freshness.
Crumb trays
B
WARNING: Crumbs will
accumulate in the crumb tray
and could catch fire if not
emptied periodically.
When the toaster has cooled down Model no.
completely, tap the sides of the case
lightly to dislodge any crumbs
lodged in the toasting chamber and All Morphy Richards products are
remove the crumb trays ‡. Empty
individually tested before leaving the
the tray and replace it. factory. In the unlikely event of any
appliance proving to be faulty within
Never operate the toaster without 28 days of purchase it should be
the crumb trays fitted. returned to the place of purchase
for it to be replaced.
Cleaning and maintenance
If the fault develops after 28 days
and within 24 months of original
1 After use and before cleaning, purchase, you should contact
remove the plug from the wall socket Morphy Richards quoting Model
and wait for the toaster to cool. number and Serial number on the
product, or write to Morphy
2 Wipe the outside of the toaster with Richards at the address shown.
a damp cloth only and dry with
another cloth or tissue. You may be asked to return a copy
of proof of purchase.
• NEVER use metal polish or coarse
scouring agents and never immerse Subject to the exclusions set out
your toaster in any sort of liquid. below (1-6) the faulty appliance will
then be repaired or replaced and
• NEVER use any pointed or sharp dispatched usually within 7 working
articles for cleaning the inside, days of receipt.
otherwise the heating element will be
damaged. If for any reason this item is
replaced during the 2-year
• NEVER use a brush or push your guarantee period, the guarantee on
fingers or metal objects down the the new item will be calculated from
slots. original purchase date. Therefore it
is vital to retain your original till
receipt or invoice to indicate the
Helpline date of initial purchase.
If you have any difficulty with your To qualify for the 2-year guarantee
appliance, do not hesitate to call us.
the appliance must have been used
according to the manufacturers
We are more likely to be able to instructions. For example,
help than the store from where you appliances must have been
bought it. descaled and filters must have been
kept clean as instructed.
Please have the following
information ready to enable our staff Morphy Richards shall not be liable
to deal with your query quickly. to replace or repair the goods under
the terms of the guarantee where:
• Name of the product
1 The fault has been caused or is
• Model number as shown on the attributable to accidental use,
underside of the appliance. misuse, negligent use or used
contrary to the manufacturers
recommendations or where the fault
Your two-year guarantee has been caused by power surges
or damage caused in transit.
It is important to retain the retailers
receipt as proof of purchase. Staple 2 The appliance has been used on a
your receipt to this back cover for voltage supply other than that
future reference. stamped on the products.
Please quote the following 3 Repairs have been attempted by
information if the product develops persons other than our service staff
a fault. These numbers can be (or authorised dealer).
found on the base of the product.
Serial no.
o
5