Troy-Bilt 410 Series Operator's Manual page 5

Chipper shredder
Hide thumbs Also See for 410 Series:
Table of Contents

Advertisement

Available languages

Available languages

3.
Before cleaning, repairing, or inspecting, stop the engine
and make certain the impeller and all moving parts have
stopped. Disconnect the spark plug wire and ground it
against the engine to prevent unintended starting.
4.
Do not change the engine governor settings or overspeed
the engine. The governor controls the maximum safe
operating speed of the engine.
5.
Maintain or replace safety and instruction labels, as
necessary.
6.
Follow this manual for safe loading, unloading,
transporting, and storage of this machine.
7.
Never store the machine or fuel container inside where
there is an open flame, spark or pilot light such as a water
heater, furnace, clothes dryer, etc.
8.
Allow machine to cool at least 5 minutes before storing.
9.
Always refer to the operator's manual for proper
instructions on off-season storage.
10.
If the fuel tank has to be drained, do this outdoors.
11.
Observe proper disposal laws and regulations for gas, oil,
etc. to protect the environment.
12.
According to the Consumer Products Safety Commission
(CPSC) and the U.S. Environmental Protection Agency (EPA),
this product has an Average Useful Life of seven (7) years,
or 60 hours of operation. At the end of the Average Useful
Life have the machine inspected annually by an authorized
service dealer to ensure that all mechanical and safety
systems are working properly and not worn excessively.
Failure to do so can result in accidents, injuries or death.
Do not modify engine
To avoid serious injury or death, do not modify engine in any
way. Tampering with the governor setting can lead to a runaway
engine and cause it to operate at unsafe speeds. Never tamper
with factory setting of engine governor.
Notice Regarding Emissions
Engines which are certified to comply with California and federal
EPA emission regulations for SORE (Small Off Road Equipment)
are certified to operate on regular unleaded gasoline, and
may include the following emission control systems: Engine
Modification (EM), Oxidizing Catalyst (OC), Secondary Air
Injection (SAI) and Three Way Catalyst (TWC) if so equipped.
Spark Arrestor
WARNING:
This machine is equipped with an
internal combustion engine and should not be used
on or near any unimproved forest-covered, brush
covered or grass-covered land unless the engine's
exhaust system is equipped with a spark arrester
meeting applicable local or state laws (if any).
If a spark arrester is used, it should be maintained in effective
working order by the operator.
A spark arrester for the muffler is available through your nearest
engine authorized service dealer.
S
2 — i
ection
mportant
S
o
p
afe
peration
racticeS
5

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

420 series

Table of Contents