Korg M1 Owner's Manual page 45

KEY SYNC ...............................................[DISABLE, ENABLE]
ENABLE: The phase of the MG (Modulation Generator) will
be reset by each note-on.
INTENSITY ............................................................. [00...99]
Specifies the depth of modulation.
DELAY.................................................................... [00...99]
Specifies the time from note-on until when modulation is
applied.
TEMPO SYNC...........................................[DISABLE, ENABLE]
ENABLE: The MG frequency will be synchronized accord-
ing to the "BASE NOTE" setting.
DISABLE: The MG frequency can be specified indepen-
dently of the tempo.
If you've selected a MIDI device in the "Clock Master"
setting of the Settings-MIDI Settings dialog box, the
MG will synchronize to the MIDI Clock from that
MIDI device. If you're using the M1 software synthe-
sizer as a plug-in, the MG will synchronize to the
tempo of the host application.
FREQ/TIMES ............................................... [00...99/1...16]
If "TEMPO SYNC" is set to ENABLE, this setting deter-
mines the MG frequency in conjunction with the "BASE
NOTE" setting. If "TEMPO SYNC" is set to DISABLE, this
setting directly specifies the MG frequency.
BASE NOTE...................................................... [1/1...1/32]
If "TEMPO SYNC" is set to ENABLE, one cycle of the MG
will occupy a length equivalent to the "TIMES" number
(specified in "FREQ/TIMES") of the note values specified
by "BASE NOTE" relative to the synchronized tempo.
If "TEMPO SYNC" is set to DISABLE, this setting is ignored.
When "BASE NOTE" = 1/4 (quarter note), the MG cycle will
be:
• If "TIMES" =1 (one beat per MG cycle)
• If "TIMES" =2 (two beats per MG cycle)
• If "TIMES" =4 (four beats per MG cycle)
When "BASE NOTE" = 1/16 (sixteenth note), the MG cycle
will be:
• If "TIMES" =1 (four MG cycles per beat)
• If "TIMES" =2 (two MG cycles per beat)
• If "TIMES" =4 (one MG cycle per beat)
Combination mode
41