Receiving Volume; Ring Tone/Volume - NEC Dterm Cordless II DTR-4R BK User Manual

Muting
1. Press MUTE during conversation.
The 'TALK' icon blinks and the voice through the microphone is muted.
2. Press MUTE again to cancel the muted condition. (Finishing the conversation also cancels
the mute condition.)
The 'TALK' icon stops blinking.
Conferencing
This feature allows the user to set up a 3-party conference.
1. During a conversation, press CONF.
2. Dial the number for the second conference party.
3. Press CONF again to establish a 3-party conference.

Receiving Volume

1. During a conversation, press R/VOL to change the ear speaker volume setting.
The telephone has four receiver volume levels: Low, Medium, High, Maximum.
2. Continue to press R/VOL until the desired volume is selected.
When you hang up, the telephone retains the last selected volume.

Ring Tone/Volume

In standby mode, press R/VOL to change the ring tone and volume.
In standby mode, press R/VOL.
The selected tone and volume rings for about two seconds. The display shows ring
tone: Type A – High/Low, Type B – High/Low, Type C – High/Low, OFF – Vibrate.
If R/VOL is pressed while the ringer tone is sounded, the handset stops ringing and goes to
the next tone setting.
The LCD display disappears after the selected tone/volume rings for about two
seconds.
4