Power; Adjusting Volume; Changing Channels - JVC AV 27050 User Manual

POWER

Make sure that the TV/CATV switch is set to TV. Switch to CATV only to operate a cable box.
P ress the P button on the remote control or the TV front panel. The On Timer lamp will glow red.
O W E R
The first time you turn on the TV, the "Plug In Menu" will appear. You should turn to the Plug In
Menu section (page 15) now to learn more about this menu.
To turn the power off, press the P
When the TV is off, the On-Timer lamp remains on while the On/Off Timer function is active, but at
a reduced brightness.

ADJUSTING VOLUME

Use the V –/+ buttons (
1
OLUME
button to lower the volume. Press the V
Press the M
2
UTING
previous volume level, simply press the M

CHANGING CHANNELS

1 10 key direct access.
Press the numbers on the remote's 10 key pad. For single-digit channel numbers press 0 then the
number. For channels above 100, press the 100+ button plus the 2-digit number.
2
C –/+ button (
HANNEL
Press the C –/+ button, it will scan the channels in order.
HANNEL
NOTE: After you operate the Auto Tuner Setup (page 15), all of the blank, or empty, channels will be
removed from scanning so that there is no noise or channel snow when you scan, only active channels.
3
Return.
Press and release the R
(game #1). Then, select another channel (game #2) with the 10 key pad and push the R
button to flip directly back and forth.
4
Return+ .
Press and hold down the R
PROGRAMMED !" will appear and you can scan as you wish. Press R
back to the Return+ channel.
To cancel a Return+ channel, press and hold down the R
and the message, "RETURN CHANNEL CANCELLED !" appears.
Pressing a number key or turning the set off will also cancel a Return+ channel.
G E T T I N G
button again. The On Timer lamp will go out.
OWER
) on the front panel or remote control. Use the V
VOLUME 13
|||||||
button to instantly turn the volume off to zero. To restore the volume to the
).
+ button to return to the previous channel. First, select a channel
ETURN
+ button for three seconds. The message, "RETURN CHANNEL
ETURN
S T A R T E D
+ button ( ) raise the volume.
OLUME
-------------------
button again.
UTING
+ button for another three seconds
ETURN
OLUME
ETURN
+ again and you will go
ETURN
1
1
– ( )
+