Electrical Safety - Martin Audio ASX User Manual

2

Electrical safety

Read these instructions
Follow all instructions
Heed all warnings
Keep these instructions for future reference
Approvals
This equipment has been tested by a Notified Body (Directive 89/336/EEC-EMC), pursuant to the
product family standard for audio professional use, and found to comply with EN55103-1, EN55103-2
(with limits for E4 and E5 electromagnetic environment) plus EN61000–3–2 and EN 61000–3-3.
This is a Class A product. In a domestic environment this product may cause radio interferences in
which case the user may be required to take adequate measures.
This equipment has been tested and found to comply by Notified Body 0715 (Directive 73/23/EEC
L.V) pursuant to the audio apparatus safety requirements: Standard EN 60065.
Caution
To reduce the risk of electric shock, do not remove the cover. There are no user-serviceable
parts inside the unit. Refer servicing to qualified service personnel. Call Martin Audio Limited
on +44 (0)1494 535312 or email
Installation
This product is for permanent location and should be installed by a qualified engineer. The
supply cable used should have conductors 1.5mm sq (14 AWG) or greater and must comply
with local regulations
The installer must provide a means of disconnection. This could be of the form of a mains
plug, an all pole mains switch, or an all pole circuit breaker. Where an all-pole mains switch
or circuit breaker is used, it must have a contact separation of 3mm in each pole and must
disconnect all poles simultaneously.
Safeguards
Electrical energy can perform many useful functions. This unit has been engineered and
manufactured to assure your personal safety. Improper use can result in potential electrical
shock or fire hazards. In order not to defeat the safeguards, observe the following
instructions for installation and use.
All material © 2009. Martin Audio Ltd. PRELIMINARY
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
This equipment has been tested by a Notified Body (Directive
89/336/EEC-EMC), pursuant to the product family standard for
audio professional use, and found to comply with EN55103-1 and
EN55103-2 standard (with the limits for E1, E2 and E3
electromagnetic environment) plus EN61000–3–2, EN61000–3-3.
This equipment has been tested and found to comply by Notified
Body 0715 (Directive 73/23/EEC L.V) pursuant to the audio
apparatus safety requirements: Standard EN 60065.
info@martin-audio.com
!
for service advice.