Lennox HP23-141 Installation Instructions Manual

Hp23 series
Hide thumbs Also See for HP23-141:

Advertisement

Quick Links

352'8&7 /,7(5$785(
¤
 /HQQR[ ,QGXVWULHV ,QF
'DOODV 7H[DV
+3 +($7 3803 81,7
+3 KHDW SXPS XQLWV DUH DSSURYHG DQG ZDUUDQWHG
RQO\ IRU LQVWDOODWLRQ ZLWK VSHFLDOO\ PDWFKHG LQGRRU
FRLOV / OLQH VHWV DQG UHIULJHUDQW FRQWURO GHYLFHV DV
GHVLJQDWHG E\ /HQQR[
handbook for expansion valve kits which must be
ordered separately.
6+,33,1* $1' 3$&.,1* /,67
1- - Assembled HP23 heat pump unit
Check unit for shipping damage. Consult last carrier
immediately if damage is found.
*(1(5$/ ,1)250$7,21
These instructions are intended as a general guide
and do not supersede national or local codes in any
way. Authorities having jurisdiction should be con-
sulted before installation.
,03257$17
7KH &OHDQ $LU $FW RI  EDQV WKH LQWHQWLRQDO
YHQWLQJ RI UHIULJHUDQW &)&·V DQG +&)&·V DV RI
-XO\   $SSURYHG PHWKRGV RI UHFRYHU\ UH
F\FOLQJ RU UHFODLPLQJ PXVW EH IROORZHG )LQHV
DQGRU LQFDUFHUDWLRQ PD\ EH OHYLHG IRU QRQFRP
SOLDQFH
£
Refer to Lennox engineering
,167$//$7,21
,16758&7,216
+3 6(5,(6 81,76
+($7 3803 81,76
 WKURXJK  WRQ
0

6XSHUVHGHV 0
7$%/( 2) &217(176
+3 +($7 3803 81,7
6+,33,1* $1' 3$&.,1* /,67
*(1(5$/ ,1)250$7,21
+3 81,7 ',0(16,216
+3 &+(&. 32,176
6(77,1* 7+( 81,7
(/(&75,&$/
                                     
3/80%,1*
                                       
5()5,*(5$17 0(7(5,1* '(9,&(
0$1,)2/' *$8*( 6(7
/,48,' 9$325 /,1( 6(59,&( 9$/9(6
/($. 7(67,1*
(9$&8$7,21
                                    
67$5783
                                       
&+$5*,1* &216,'(5$7,216
&+$5*,1* )25 5)& 6<67(06
&+$5*,1* )25 7;9 6<67(06
6<67(0 23(5$7,21
0$,17(1$1&(
5(7$,1 7+(6( ,16758&7,216
)25 )8785( 5()(5(1&(
3URGXFW FRQWDLQV ILEHUJODVV ZRRO
'LVWXUELQJ WKH LQVXODWLRQ LQ WKLV SURGXFW GXULQJ
LQVWDOODWLRQ PDLQWHQDQFH RU UHSDLU ZLOO H[SRVH
\RX WR ILEHUJODVV ZRRO %UHDWKLQJ WKLV PD\ FDXVH
OXQJ FDQFHU )LEHUJODVV ZRRO LV NQRZQ WR WKH
6WDWH RI &DOLIRUQLD WR FDXVH FDQFHU
)LEHUJODVV ZRRO PD\ DOVR FDXVH UHVSLUDWRU\ VNLQ
DQG H\H LUULWDWLRQ
7R UHGXFH H[SRVXUH WR WKLV VXEVWDQFH RU IRU IXU
WKHU LQIRUPDWLRQ FRQVXOW PDWHULDO VDIHW\ GDWD
VKHHWV DYDLODEOH IURP DGGUHVV VKRZQ EHORZ RU
FRQWDFW \RXU VXSHUYLVRU
/HQQR[ ,QGXVWULHV ,QF
32 %R[ 
'DOODV 7; 
3DJH 
                           
                     
                         
                          
                             
                               
                
                           
                                   
                    
                  
                  
                            
                                  
:$51,1*
/LWKR 86$










           










Advertisement

Table of Contents
loading

Summary of Contents for Lennox HP23-141

  • Page 1                                    RQO\ IRU LQVWDOODWLRQ ZLWK VSHFLDOO\ PDWFKHG LQGRRU FRLOV / OLQH VHWV DQG UHIULJHUDQW FRQWURO GHYLFHV DV Refer to Lennox engineering GHVLJQDWHG E\ /HQQR[ 5(7$,1 7+(6( ,16758&7,216 handbook for expansion valve kits which must be )25 )8785( 5()(5(1&(...
  • Page 2: Top View

    HP23 UNIT DIMENSIONS- -INCHES (MM) INLET FAN GUARD Model No. HP23-141, HP23-211, 26-3/8 26-3/8 16-7/8 INLET INLET HP23-261 HP23-311, 26-3/8 30-3/8 16-7/8 HP23-411-413 HP23-461-463, HP23-511-513, 31-5/16 34-3/8 21-3/16 HP23-651-653 INLET TOP VIEW DISCHARGE CONTROL ELECTRICAL CONNECTIONS BOTTOM OF COMPRESSOR CONTROL BOX...
  • Page 3: Setting The Unit

    Slab Mounting- -Figure 2 SETTING THE UNIT When installing unit at grade level, top of slab should Heat pump units operate under a wide range of be high enough above the grade so that water from weather conditions; therefore, several factors must be considered when positioning the outdoor unit.
  • Page 4 If unit coil cannot be mounted away from prevailing 2- - Route power and ground wires from disconnect winter winds, a wind barrier should be constructed. switch to unit. Electrical openings are provided Size barrier at least the same height and width as out- under the control box cover.
  • Page 5: Refrigerant Metering Device

    (sweat connections) to the CAN BE INSERTED AND READ EASILY indoor evaporator coil (typically flare connections). THERMOMETER WELL- -MALE Use Lennox L10 series line sets as shown in table 1 or LIQUID LINE- -FEMALE LIQUID CONNECTION use field- -fabricated refrigerant lines.
  • Page 6: Expansion Valve Systems

    Expansion Valve Systems 7$%/(  ,1'225 &+(&. $1' (;3$16,21 9$/9( .,76 ([SDQVLRQ YDOYHV HTXLSSHG ZLWK HLWKHU k&KDWOLIIl RU IODUH 02'(/ .,7 180%(5 W\SH ILWWLQJV DUH DYDLODEOH IURP /HQQR[ 5HIHU WR WKH LQGRRU FRLO LQVWDOODWLRQ LQVWUXFWLRQV RU WKH HQJLQHHULQJ KDQGERRN +3  /% %- /% %( +3 ...
  • Page 7: Liquid Line Service Valve

    CAUTION Liquid Line Service Valve ( Figure 8) The valve is equipped with a service port. There is no The service port cap is used to seal the liquid schrader valve installed in the liquid line service port. A line service valve. A schrader valve is service port cap is supplied to seal off the port.
  • Page 8 3- - Replace stem cap. Tighten finger tight, then tighten VAPOR LINE SERVICE VALVE (VALVE OPEN) an additional 1/6 turn. SNAP RING INSERT HEX /($. 7(67,1* KNIFE EDGE WRENCH HERE SEAL INLET After the line set has been connected to the indoor (FROM INDOOR COIL) and outdoor units, the line set connections and in- door unit must be checked for leaks.
  • Page 9 (9$&8$7,1* 7- - Reconnect the manifold gauge to the vacuum pump, turn the pump on and continue to evacuate Evacuating the system of non- -condensables is criti- the line set and indoor unit until the absolute pres- cal for proper operation of the unit. Non- -condens- sure does not rise above 5mm of mercury within a ables are defined as any gas that will not condense 20 minute period after shutting off the vacuum...
  • Page 10 TABLE 5- - When thermostat demand has been satisfied, Ozs. per 5 ft. (ml per mm) adjust switch to cooling mode with a set point of 68 Liquid Line Set Diameter from 20 ft. (6096 mm) line set* When pressures have stabilized, place the ther- mometer in thermometer well and record the liq- 1/4 in.
  • Page 11: Compressor Oil Charge

    Compressor Oil Charge time, record the liquid line temperature and the liquid line pressure reading. Refer to Lennox Cooling Service Handbook for cor- Using a temperature/pressure chart for R22, de- 4- - rect procedure to check and add compressor oil. Heat termine the saturation temperature for the liquid line pressure reading.
  • Page 12: Crankcase Heater

    The defrost thermostat is mounted on the liquid line 1- Clean or change filters. between the check valve/drier and the distribu- 2- Lennox blower motors are pre- -lubricated and per- tor.When defrost thermostat senses 35 F (2 C) or manently sealed. No further lubrication is neces- cooler, its contacts close and send a signal to the de- sary.

Table of Contents