Before You Begin; Completed Installation; Assembly - Merlin MT5580P Installation And Operating Instructions Manual

BEFORE YOU BEGIN

5
1. Look at the wall or ceiling above the garage door. The header bracket must be securely fastened to structural
supports.
2. Do you have a finished ceiling in your garage? If so, a support bracket and additional fastening hardware
(not supplied) may be required.
3. Do you have an access door in addition to the garage door? If not, model CM1702 outside quick release accessory
is required. This accessory allows manual operation of the garage door from outside in case of power failure.
4. Complete the following test to make sure your garage door is balanced and is not sticking or binding:
• Lift the door about halfway. Release the door. If balanced, it should stay in place, supported
entirely by its springs.
• Raise and lower the door to see if there is any binding or sticking. If your door binds, sticks, or is out of
balance, call a trained door technician.
COMPLETED INSTALLATION (TILT DOOR EXAMPLE SHOWN)
6
As you proceed with the assembly, installation and adjustment procedures in this manual, you may find it helpful to
refer back to this illustration of a completed installation for tilt doors (for sectional doors refer section 22).
1
13
(1) Header bracket
(2) Idler pulley assembly
(3) Trolley
(4) Pole
(5) Chain
(6) Hanging bracket
ASSEMBLE POLE PACK
7
Remove the 5 sectional poles from the carton and lay
them out on the floor. The end pole (i.e. the pole with-
out a tapered edge) should be placed at the header
end.
Assemble the poles by inserting the tapered end into
the non-tapered end of the next pole as illustrated.
Ensure that the each pole is pushed firmly into the
next.
NOTE: If using a mallet to drive the joins home,
use a piece of timber at each end to minimise
burring.
3
2
11
12
(7) Power cord
(8) Opener
(9) Light lens
(10) Manual release rope & handle
(11) Curved door arm
(12) Straight door arm
ASSEMBLY SECTION
4
5
15
9
DOOR
14
10
(13) Door bracket and plate
(14) Trolley release arm
(15) Stop Collar
5
6
7
professional
www.chamberlainanz.com
8