Further, ViewSonic reserves the right to revise this publication and to make changes from time to time in the contents hereof without obligation of ViewSonic to notify any person of such revision or changes.
3. Keep wires away from high voltage, high temperature components and sharp edges. 4. Keep wires in their original position so as to reduce interference. 5. Usage of this product please refer to also user's manual. Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 5
Only touch the metal frame of the LCD panel Surface of the LCD panel is pressed by fingers or the front cover of the LCD TV. Do not touch and that may cause “Mura” the surface of the polarizer. Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 6
That may cause “Mura” Place the LCD TV on a clean and soft foam Placing the LCD TV on foreign objects. That pad. could scratch the surface of the panel or cause “Mura” Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Rang: NTSC 55.25 to 801.25 MHz, 2-69 channels for Off-Air and 2-125 Channeis for CATV Power Voltage: 100~240 V Consumption: 200 Watts (Max.) Speaker 10W×2 Compliance FCC,UL Temperature Operating : 0°C~ +40°C Storage : -20°C~+60°C Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 8
V TOTAL 16.666ms 13.328ms 16.667ms 16.666ms V DISPLAY 15.880ms 12.795ms 16.000ms 15.880ms V B-Porch 0.600ms 0.466ms 0.444ms 0.600ms Vs Width 0.124ms 0.050ms 0.111ms 0.124ms V Border 0.000ms 0.000ms 0.000ms 0.000ms H/V Sync Interlace Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 9
The signal cable connector shall be a molded-over, shield twisted pair cable. The cable shall be 1.8 meters long. The pin assignments shall be listed as below: D-SUB Connector Red Video Green Video Blue Video +5V for DDC H-sync V-sync Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 10
12 Floating 20 Floating Floating 13 Floating 21 Floating DDC Clock 14 +5V Power 22 TMDS Ground DDC Data 15 Ground 23 TMDS Clock+ Floating 16 Hot Plug Detect 24 TMDS Clock- Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Press “▼” key to select the “ WHITE BALANCE” item in the factory mode and press “enter “key, then the white balance will be auto dadjusted . G. Color temperature verification : Warm /SRGB x=0.313±0.03 y=0.329±0.03 USER x=0.283±0.03 y=0.298±0.03 COOL x=0.271±0.03 y=0.278±0.03 Y ≥ 380 cd/m Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 12
C. LCD TV should be run-in and warmed up for at least 30 minutes. D. Make sure the distance between SENOR of the CA110 and the LCD TV is about 20cm. E. Color Temperature adjusting. Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 13
B. Pattern: TEST-TTL/ECL. C. BRIGHTNESS=MAX, CONTRAST=MAX. D. The power that each MODE consumes is shown in Chart 1. MAX POWER CONSUMED POWER LED COLOR MODE <200W GREEN NORMAL <5W ORANGE Standby <5W Chart 1 Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 14
Whether there is unusual sound, input signal LEVEL<=36dBu,and STEREO SENSITIVITY is normal. P7. Adjustment attenuator, If the critical point of the change of the image signal to noise ratio is under LEVEL<=60dBu,regards as normally. Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 16
After final QC step, we have to erase all saved changes again and restore the factory defaults. You should do “All Mode Reset” again. Power Off LCD TV. Turn off the LCD TV by pressing “Power” button. Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 17
- PC (Personal Computer) - LPT Cable - Firmware Upgrade Program - One additional LCD TV for checking the program execution Com Port N3250W(G) LCD TV RS-232 Cable (pin to pin) VGA Cable Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 18
2.2.4 Connect Power Cord to N3250W(G) LCD TV. 2.2.5 Connect PC to the additional LCD TV. 2.3. ISP Download program procedure 2.3.1 Hardware Connect status: 2.3.2 Download ISP program Step 1: Execute ISP.exe Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 19
N3250W(G) LCD TV for this project., then press the OK Button. Step 3: Load file Press the Load MCU File button to select the file (File 0 and File 1) will be downloaded. (*.Hex) Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 20
Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 21
Step 4: Test Communication Pressing the ConNect button to test whether the communication is well. Testing Result Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 22
The connecting status between ISP status and LCD TV. Turn off the power of LCD TV (AC plug off) and disconnect the D-Sub connector. To connect the D-Sub connector and then turn on the power of LCD TV.(AC plug on) Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 23
If the test result shows “Connected,” it means the connection is well. If not (failed), it means the connection has problems. Then you need to check the setup procedure or reboot the PC, or simply use another PC to do the firmware upgrade. Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 24
2. If you find the DDC does not conform to the LCD TV, you have to do the DDC key in. 3.1. Equipment Needed N3250W(G) LCD TV DDC Card RS232 cable Barcode Reader VGA Cable N3250W(G) LCD TV DDC Card RS-232 Cable VGA Cable Barcode Reader Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 25
(when key in DVI DDC information, use VGA transform to DVI port ) 3.2.4 Connect Power Cord to N3250W(G) LCD TV. 3.3. DDC Key In Procedure 3.3.1 Run DDC.exe 3.3.2 Choose model number and conform the Time then Press “ENTER” key. Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 26
3.3.3 When appear the PIC “ choose DDC Card”, Press ALT+2 Enter DDC 2B test interface. Choose DDC Card 3.3.4 Press F8 to choose corresponding model.DAT (N3250W-G.DAT press “ENTER” key) Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 27
3.3.5 Press F9 enter the download interface 3.3.6 Key in the serial number or use the barcode reader to scan the barcode of the LCD TV, and press “ENTER” key. Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 28
3.3.7 The successful picture is as follows. “Compare EDID:OK! Press any key to continue”. 3.4. Check Method Use ViewSonic EDID Editor Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 29
Connect the N3250W(G) LCD TV to PC with VGA Cable. Excute the EDID Editor, then Press Ctrl+F5. If the DDC is correct, you can see the information as follow: Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
At last, close the carton and seal it with tape. (Figure 4) 1.Power Cord 2.VGA Cable 3.SCART Cable 4.RCA Cable 5.User’s Guide 6.Remote contrl 7. GUARANT CARD 8.BATTERY Figure 4 Figure 3 Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 31
Disassembly Procedure Disassembly of Stand and Dust Cover from LCD TV. 1.1 Unscrew 4 screws that secure Stand Unit. 1.2 Detach Stand Unit from the LCD TV. Stand Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 32
1.3 Detach Dust Cover from the LCD TV. Dust Cover Dust Cover 2. Disassembly of Rear Cover. 2.1 Unscrew 16 screws to remove Rear Cover. Rear Cover Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 33
3. Disassembly of Main Board, Power Board, Keypad,IR Board,Speaker,Front Cover and Panel Unit. 3.1 Unscrew 14 screws to remove Shielding Plate. Shielding Plate 3.2. Unscrew 3 screws to remove Dust Cover. Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 34
3.3. Unscrew 3 screws to remove Metal Fittg. 3.4. Unscrew 10 screws to remove Metal Fittg. Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 35
3.5. Unscrew 4 screws and disconnect the wires to remove Main Board. Main Board 3.6. Unscrew 6 screws and disconnect the wires to remove Power Board. Power Board 3.7. Unscrew 6 screws and disconnect the wires to remove KeyPad. Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 36
Keypad Board 3.8. Unscrew 8 screws to remove Speaker. Speaker 3.9. Unscrew 6 screws to remove Bracket Bracket Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 37
3.11. Unscrew 4 screws to remove IR Board. IR Board 3.12. Lay Panel Unit facedown and unscrew 6 screws on its right and left sides, to remove Panel Unit and Panel Bracket. Panel Bracket Panel Unit Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 40
S-VIDEO TV model SCART SCART1 Check I110 pin 2,4 C277 Check Check Check Check I118 pin 12 has Check I107 pin 27 has Check Check Replace I118 I109 pin 2,6 has I107 pin 26,34 has C262,C263,R215,R217,L signal? signal I107 pin 27 I109 pin 2,4 L135 signal? signal?
Page 41
Check I103 if RST pin81 have reset pulse I113 set reset pusle? Check I100 crystal 14.318MHZ if working? Change I103 Check P116 data bus have signal Check panel power 5v Change LCD panel Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
The component, composite, or S-Video signals are sampled at a free-run external clock frequency (10~58.6 MHz). After the video decoder processing, the video data was sent out with a line-locked alignment rate (24.576 MHz). The SAA7117 comes with 160-pin QFP package. Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 64
The Antenna receive the TV signal and modulate it to the CVBS signal which can be recognized by the decoder and FM-stereo/FM-mono/NICAM audio signal output to the sound Automatic standard decoder IC MSP3410G. The MCU can automatic detect the tuner and send order by serial bus. Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 65
12. Wiring Diagram Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 66
13. PCB Layout Diagrams 13.1. MAIN PCB TOP VIEW Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 67
13.2. MAIN PCB BOTTOM VIE W Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 68
13.3. KEYPAD PCB TOP VIEW 13.4. KEYPAD PCB BOTTOM VIEW Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 69
13.5. IR PCB TOP VIEW Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Page 70
13.6. IR PCB BOTTOM VIEW Confidential - Do Not Copy ViewSonic Corporation N3250w-G...
Add.: Fax: Tel: E-mail: After completing this form, please return it to ViewSonic Quality Assurance in the USA at facsimile 1-909-839-7943. You may also e-mail any suggestions to the Director, Quality Systems & Processes (marc.maupin@viewsonic.com) Confidential - Do Not Copy...