Installation - Russound Acclaim 7 Series Installation Manual

Installation

1. Remove the grille and baffle from the speaker by turning counterclockwise
the four twist lock knobs in the four corners.
2. Center the frame in the cutout. Make sure the speaker is level. Tighten the
screws equally until the clamps secure the frame. Do not overtighten.
Cutout
Speaker cable
Frame
Install speaker frame
As screws are tightened
clamp will rotate out and
snug against the drywall.
Screws
Russound In-wall Fixed Tilt Loudspeaker Installation Manual
3. Connect the speaker wire to the speaker terminals:
• Leave about 1' (30.5 cm) of wire extending through the cutout.
• Pull the conductors apart so the last two inches are separated and
remove 1/2" (1.3 cm) of insulation from the end of each conductor.
• Twist the strands in each conductor into tight spirals.
• Attach the speaker wires to the red and black speaker terminals.
Connect the Positive (+) conductor to the Red terminal and the Negative
(-) conductor to the Black terminal. Make sure that no stray strands of
wire are touching the other conductor or terminal.
(+)
Insertion of speaker wire on back of speaker baffle
InStAllAtIon
(-)
9