Installing Dv Capture Drivers; For Windows 98 - JVC VIDEO NAVIGATOR GV-DV1000 Before Using

10
EN
Caution
• In case the DV Capture Board has been installed with Windows
required.
FOR WINDOWS
Before you use the DVC Capture Board, you must install the DV Capture Board drivers. If you
have not done so already, install the DV Capture Board (see p. 8). Follow these steps to install
the drivers. If you make a mistake during the install procedure, click the Back button and
correct the mistake.
1
Turn on your computer. Put the included
JVC CD-ROM in your CD-ROM drive.
The New Hardware Found Window is
displayed.
If the New Hardware Found Window is
not displayed click the Start button on
the Task Bar and select Shut Down. In
the Shut Down Windows window select
Restart the computer and click OK.
2
The Add New Hardware Wizard is
displayed.
Click the Next button.
3
Make sure Search for the best driver for
your device. (Recommended). is
selected. Then click the Next button.

INSTALLING DV CAPTURE DRIVERS

98
®
® 95, these steps are not