Device Setup - Mercury VesselView 4 User Manual

Section 2 - System Startup
1. Press the arrow buttons to highlight the engine location. Press the enter button to turn it off or on. VesselView can only
display information for up to two engines.
2. Press the arrow button to highlight which engine is to be displayed, and press enter. The following is a description of what
may be available, depending on the number of engines:
• NONE
• STBD
• PORT
• STBDCNTR (triples and quads)
• PORTCNTR (quads only)
3. Press the arrow button to highlight Next to continue to device setup.

Device Setup

The unique VesselView ID differentiates each VesselView unit from all other installed SmartCraft devices. The DEVICE SETUP
screen enables you to assign this unique identifier to each VesselView unit and to designate whether the VesselView is
installed at the primary or secondary helm.
IMPORTANT: Do not choose the same unique VesselView ID for multiple VesselView installations.
1. If there is only one VesselView unit installed on the vessel, proceed to step 5; otherwise, press the enter button to access
the UNIQUE VESSELVIEW ID option.
NOTE: Select the ID by the position of the installed VesselView (lowest to highest helm is recommended).
2. Press the enter button to open the Unique VesselView ID option. Use the arrow button to highlight the ID number and
press enter. Choose a number that is different from the other numbers assigned to any other VesselView unit installed.
3. Press the arrow button to highlight the HELM ID option and press enter.
NOTE: Use 1 for a single‑helm vessel. If a vessel has multiple VesselView units installed at different helms, the ID number
represents the helm location. Lowest to highest helm is recommended.
4. Press the arrow button to highlight the helm ID selection and press enter.
Page 10
DISPLAY SETUP
Select which engines to show on this
display.
Port
Stbd
Previous
Next

DEVICE SETUP

Unique VesselView ID:
1
Helm ID:
1
Previous
Next
50722
50750
90-8M0074776 MAY 2013
eng