Before Using For The First Time; Installing The Unit; Connecting To The Analog Output Jacks; Connecting To The Digital Output Jack - JVC XL-FZ700 Instructions Manual

Before using for the first time

Installing the unit

Best location
Select a location which is level, dry and neither too cold
nor too hot (temperature range 5°C to 35°C). Also, avoid
dusty locations or any location subject to vibration.
If interference occurs
If this unit is placed near a tuner or a radio receiver tuned
to AM frequencies, interference may occur. If this
happens, we recommend either that you move this unit
as far as possible from the tuner or receiver or briefly
turn off the power of this unit.
Connecting to the Analog
Output Jacks
Connecting to an amplifier or receiver allows you to
listen to the sound from the speakers.
Connect the OUTPUT jacks of this unit to the line input
jacks of an amplifier or receiver with the supplied audio
cord.
NOTES
• Never connect the OUTPUT jacks to the PHONO jacks
of the amplifier or receiver. This may cause damage to
the components.
• Make sure that the same channels are connected
between this unit and the amplifier or receiver: LEFT to
LEFT and RIGHT to RIGHT.
• Do not connect the power plug until all connections are
complete.
• Connect the plugs firmly. Loose connections may cause
noise or malfunction.
COMPU LINK - 3 AC IN AC IN
DIGITAL
(SYNCHRO)
OUTPUT
OUT
OPTICAL RIGHT LEFT
OUTPUT
RIGHT LEFT
Connecting to the Digital
Output Jack
It is possible to transmit a digital sound signal from this
unit directly to a MD recorder, etc.
NOTES
• Never connect the digital output cable except to the
digital input jack.
• An optical digital cord (optional) is required to make
this connection. Refer to the instruction manual of the
MD recorder, etc. for details.
COMPU LINK - 3
AC IN AC IN
DIGITAL
(SYNCHRO)
OUT OUTPUT
OPTICAL RIGHT LEFT

Supplying the power

To connect the AC power cord of the
main unit
The AC power cord is supplied separately and must be
connected to the unit.
Plug the AC power cord into the
this unit and connect to the wall outlet after all
connections are complete.
NOTE
• When using the COMPU LINK Remote Control System
(see page 6), do not connect the power cord to the
SWITCHED AC OUTLET of an amplifier or receiver.
COMPU LINK - 3
DIGITAL
(SYNCHRO)
OUTPUT
OUT
OPTICAL RIGHT LEFT
English
AC IN connector of
AC IN AC IN
(to be continued)
5