Connecting Other Equipment; Adjusting The Voltage Selector; Canceling The Display Demonstration - JVC SP-MXK50 Instructions Manual

Connecting Other Equipment

You can connect an audio equipment.
• DO NOT connect any equipment while the power
is on.
• DO NOT plug in any equipment until all
connections are complete.
To connect an analog component
Be sure that the plugs of the audio cords are color coded:
White plugs and jacks are for left audio signals, and red ones
for right audio signals.
To audio output
For playing the other equipment through this unit,
connect between the audio output jacks on the other
equipment and AUX IN jacks by using audio cords (not
supplied).

Adjusting the Voltage Selector

Before plugging in the unit, set the correct voltage for your
area with the voltage selector on the rear of the unit.
220
VOLTAGE
SETTING
Use a screw driver to rotate the voltage selector so the voltage
number the voltage mark is pointing at is the same as the
voltage where you are plugging the this unit. (See the back
cover page.)
DO NOT plug in before setting the voltage selector
on the rear of the unit and all connection
procedures are complete.
AUX IN
Audio/video
equipment
S P E A K E R
[ 6-16 ]
L
R
220
VOLTAGE
SETTING
NOW, you can plug in the unit and other
connected equipment FINALLY!

Canceling the Display Demonstration

When connecting the AC power cord into a wall outlet, the
unit automatically starts display demonstration.
On the unit ONLY:
To cancel the display demonstration, press
CANCEL/DEMO.
When you press other buttons
The display demonstration stops temporarily. It will start
automatically again (if no operation is done for 2 minutes) until you
cancel it by pressing CANCEL/DEMO.
To start the display demonstration manually
Press and hold CANCEL/DEMO again for more
than 2 seconds.
– 8 –
CANCEL
/ DEMO
CANCEL
/ DEMO