Hotpoint Aquarius WD420P Service Information page 30

5. Remove the lower rear access panel (B).
6. Remove the motor (M).
7. Remove the top balance weight (Nb).
8. Remove the drum assembly (Va).
9. Remove the drain pump (T).
10. Unscrew feet, remove the wheels, and remove hose clips from the rear of the cabinet.
Y Power / Control Module !
1. Remove back panel (B).
Ensure the electrical supply is disconnected. See notes on Page 2.
2. Remove screw or screws securing module support to the cabinet.
3. Disconnect wiring.
4. Lift module and support clear.
5. When replacing the board an EEProm will also be required - refer to following page.
Note: To remove and fit the EEProm use Insulated Tweezers Part No. C00066292 as shown
below.
On the original control board, the EEProm may be soldered to the board and cannot be
removed.
IC Removal Tool
EEPROM Removal from PCB
30