Tuning Into A Preset Station - JVC KD-S811R Instructions Manual

Manual preset
You can preset up to 6 stations in each band (FM1,
FM2, FM3 and AM) manually.
Ex: Storing an FM station of 88.3 MHz into the
preset number 1 of the FM1 band
1
Select the FM band (FM1 – 3) you
want to store FM stations into (in
this example, FM1).
• Each time you press the button, the FM
band changes as follows:
FM1
2
Tune into a station of 88.3 MHz.
3
Press and hold the number button (in
this example, 1) for more than 2
seconds.
4
Repeat the above procedure to store
other stations into other preset
numbers.
8
FM2 FM3
Press ¢
to tune in
stations of higher
frequencies.
Press 4
to tune in
stations of lower
frequencies.
"P1" flashes for a few
seconds.
Notes:
• A previously preset station is erased when a new station
is stored in the same preset number.
• Preset stations are erased when the power supply to the
memory circuit is interrupted (for example, during
battery replacement). If this occurs, preset the stations
again.

Tuning into a preset station

You can easily tune into a preset station.
Remember that you must store stations first. If you
have not stored them yet, see "Storing stations in
memory" on page 7.
1
Select the band (AM, FM1 – 3).
FM1
AM
2
Select the number (1 – 6) for the preset
station you want.
FM2 FM3