Procedure 6.4 - Replacing The Lift Motor - Precor 9.21 Service Manual

Procedure 6.4 - Replacing the Lift Motor

WARNING
Always turn off the circuit breaker and unplug the treadmill before you remove the treadmill hood.
Removing the Lift Motor
1. Remove the hood.
2. Disconnect the lift motor wiring assembly from the lower PCA.
3. Remove the ground wire from the lift motor ground stud on the treadmill frame.
Note:
Place a drop cloth under the treadmill to protect the flooring and to ensure that the treadmill
handrails are not scratched or damaged.
4. Place the treadmill on its right side.
5. Remove the hitch pin from the clevis pin that holds the top of the lift motor to the treadmill
frame. Remove the clevis pin from the top of the lift motor (see Diagram 5.1).
Diagram 5.1 - Lift Motor
9.21, 9.21i, 9.21S, 9.21Si Treadmill
Page 28