Polycom Soundstation Ip - Polycom SoundStation IP 6000 Quick Start Manual

Features of the Polycom SoundStation IP 6000 Conference Phone
Become familiar with the phone
Configuring the Polycom SoundStation IP 6000 Conference Phone
Pre-installation
1. Ensure an OS ext. # is assigned to this device and you know the PIN/password
2. Ensure a DID is assigned to the extension
3. Select ''Cannot be dialed'' when setting Access from Auto-Attendant preference
4. If your OfficeSuite service is OfficeSuite FlexConnect, FlexConnect Small Office, or OfficeSuite
Nationwide via DIA continue with section A. below.
5. If your service is OfficeSuite On-net or OfficeSuite Nationwide via MPLS skip to section B.
below.
A. If you connect to OfficeSuite via the Public Internet
To manually configure the Polycom with a static IP address and subnet mask, follow these steps:
1. Plug Polycom into LAN (PoE or Power brick where needed)
2. Plug Laptop into same LAN as Polycom
3. Obtain and record:
a. Single Static IP Address for this device (IP Address: ______________________)
b. Subnet Mask (Subnet Mask: ______________________)
c. Default Gateway (Gateway: _______________________)
4. In order to do so complete the following:
a. On PC Open up cmd prompt (Windows XP - start, run, cmd; Windows 7 -- - start,
type in cmd; Windows 8 -- - go to task menu, right click, select show all items,
Copyright © 2014 Broadview Networks
Quick Start Guide for the

Polycom SoundStation IP 6000

Conference Phone For OfficeSuite®
3