Harman Kardon AVR 1650 Owner's Manual page 53

harman/kardon®
bvHARMAN
IMPORTANT SAFETY INSTRUCTIONS
For All Products:
~///////////////////////////////////////////////////////////////////////////////////////////////////,(.
~ ~
~ ~
~
1. Read these instructions.
~
~
2. Keep these instructions.
~
~
3. Heed all warnings.
~
~
4 Follow all instructions.
~
~
.
~
~
5. Do not use this apparatus near water.
~
~
6 Clean only with a dry cloth.
~
~
.
~
~
7. Do not block any ventilation openings.
~
~
Install this apparatus in accordance with
~
~ the manufacturer's instructions. ~
~
8. Do not install this apparatus near any heat
~
~ ~
~
sources such as radiators, heat registers,
~
~ stoves or other apparatus (including ~
~
amplifiers) that produce heat.
~
~ ~
~ 9. Do not defeat the safety purpose of ~
~
the polarized or grounding-type plug. A
~
~
polarized plug has two blades with one
~
~ ~
~ wider than the other. A grounding-type ~
~
plug has two blades and a third grounding
~
~
prong. The w1de blade or the third prong
i
~ is provided for your safety. If the provided ~
~
plug does not fit into your outlet, consult an
~
~
I .
~
~ e ectncian for replacement of the obsolete ~
~
outlet.
~
~
10. Protect the power cord from being walked
~
~ on or pinched, particularly at plugs, ~
~
convenience receptacles and the point
~
~
where they exit from the apparatus.
~
~ ~
~
11. Use only attachments/accessones specified
~
~
by the manufacturer.
~
~ ~
~
12. Use only with the cart, stand,
~
~
tnpod, bracket or table
i\1-
~
~
.
.
~
~
specified by the manufacturer _
~
~
or sold w1th the apparatus.
~
~
When a cart is used, use caution when
~
~ ~
~
moving the cart/apparatus combination to
~
~
avoid injury from tip-over.
~
~ ~
~
13. Unplug th1s apparatus during lightning
~
~
storms or when unused for long periods
~
~
of time.
~
~ ~
~
14. Refer all servicing to qualified serv1ce
~
i
personnel. Servicing is required when the
i
~ apparatus has been damaged in any way, ~
~
such as when the power-supply cord or
~
~
I
~
~ pug 1s damaged, liquid has been spilled or ~
~
objects have fallen into the apparatus, or
~
~
the apparatus has been exposed to rain or
~
~ ~
~ mmsture, does not operate normally or has ~
~
been dropped.
~
~ ~
~ 15. Do not expose this apparatus to dripping or ~
~
splashing, and ensure that no objects filled
~
~
with liquids, such as vases, are placed on
~
~
the apparatus.
~
~
16. To disconnect this apparatus from the AC
~
~ ~
~ mains completely, disconnect the power- ~
~
supply cord plug from the AC receptacle.
~
~ ~
~ 17. The mains plug of the power -supply cord ~
~
shall remain readily operable.
~
§ §
~
18. Do not expose batteries to excessive heat
~
~
such as sunshine, fire or the like.
~
~ ~
§_///////////////////////////////////////////////////#/#///////////////////////////////////////////AI~
CAUTION
RISK OF ELECTRIC SHOCK. DO NOT OPEN.
THE LIGHTNING FLASH WITH AN ARROWHEAD
SYMBOL, WITHIN AN EQUILATERAL TRIANGLE,
IS INTENDED TO ALERT THE USER TO THE
PRESENCE OF UNINSULATED "DANGEROUS
VOLTAGE" WITHIN THE PRODUCT'S ENCLOSURE
THAT MAY BE OF SUFFICIENT MAGNITUDE TO
CONSTITUTE A RISK OF ELECTRIC SHOCK TO
PERSONS.
A
THE EXCLAMATION POINT WITHIN AN
EQUILATERAL TRIANGLE IS INTENDED TO
ALERT THE USER TO THE PRESENCE OF
IMPORTANT OPERATING AND MAINTENANCE
(SERVICING) INSTRUCTIONS IN THE LITERATURE
ACCOMPANYING THE PRODUCT.
WARNING: TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
APPARATUS TO RAIN OR MOISTURE.
For Products That Transmit
and Receive RF Energy:
FCC Regulations (USA Only)
FCC Information For Users
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference; and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
Radio and Television Interference
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio-frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause interference to radio or
television reception, which can be determined by turning
the equipment off and then on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
• Increase the separation between the equipment and
the receiver.
• Connect the equipment to a different outlet so that
the equipment and receiver are on different branch
circuits.
• Consult the dealer or an experienced radio/TV
technician for help.
NOTE: Changes or modifications not expressly approved
by HARMAN could void the user's authority to operate the
equipment.
IC Statement and Warning
(Canada Only)
This Class B digital apparatus complies with Canadian
ICES-003. Get appareil numerique de Ia classe B est
conforme
a
Ia norme NMB-003 du Canada.
For Canadian Model
This Class B digital apparatus complies with
Canadian ICES-003.
Modele pour les Canadien
Get appareil numerique de Ia classe Best conforme
a
Ia norme NMB-003 du Canada.
For Products with Radio
Receivers That Can Use an
External Antenna:
CATV (Cable TV) or Antenna Grounding
If an outside antenna or cable system is connected to this
product, be certain that it is grounded so as to provide
some protection against voltage surges and static
charges. Section 810 of the National Electrical Code
(NEG), ANSI/NFPA No. 70-1984, provides information with
respect to proper grounding of the mast and supporting
structure, grounding of the lead-in wire to an antenna
discharge unit, size of grounding conductors, location
of antenna discharge unit, connection to grounding
electrodes and requirements of the grounding electrode.
Note to CATV System Installer:
This reminder is provided to call the CATV (cable
TV)
system installer's attention to article 820-40 of the NEG,
which provides guidelines for proper grounding and,
in particular, specifies that the cable ground shall be
connected to the grounding system of the building, as
close to the point of cable entry as possible.