Using A Microphone; Using A Wired Microphone; Using A Wireless Microphone - JVC LET0089-001A Instructions Manual

Using a microphone

Using a wired microphone

Operation
1. Insert the connector cable to the end of the microphone.
2. Up to three (3) microphones can be connected to the MIC jacks
on the front panel.
MIC 1
MIN MAX MIN
3. Switch the microphone's power on.
4. Turn the MIC 1 through MIC 3 knobs clockwise (level up) or
counterclockwise (level down) as desired.
MIC 1
MIN MAX MIN
ATTENTION
When you are not using the microphone, to set the MIC switch to
OFF; otherwise the batteries will discharge even when not in use.
MIC 2 MIC 3
MAX MIN MAX
MIC 2 MIC 3
MAX MIN MAX
VARIOUS UNIQUE FUNCTIONS

Using a wireless microphone

Antenna preparations
You need to connect the FM antenna to the back of the player.
• Open the FM antenna wire connectors by pushing them to the side,
insert the FM antenna wires, and close them by pushing them back
into their original position.
• Attach the FM feeder antenna to the wall behind the player so that
the wire forms a "T" as illustrated.
WIRELESS
MIC ANT.
Microphone operation
1. Insert the antenna cable into the end of the microphone as
illustrated and turn it clockwise to secure it.
FREQ. ADJUST screw
MIC SELECT switch
Antenna cable
2. Press the WIRELESS MIC button on the front panel.
WIRELESS MIC
FM feeder antenna
(Rear panel)
WIRE-
LESS
OFF
WIRED
* Be sure to set
the switch to
OFF when
you insert the
antenna cable.
Battery compartment cap
Page 15