Air Cleaner Element Replacement - Fleetwood Bounder 1987 Owner's Manual

Fleetwood bounder motorhome owner's manual
Table of Contents

Advertisement

Replace the carburetor inlet fuel filter at the inter-
vals shown in the Maintenance Schedule. A plugged
filter and/or check valve will restrict fuel flow.
After assembling any filter element in the car-
buretor, always start the engine and check for leaks
in the fuel line and fittings before installing the air
cleaner.
Additional fuel filters for the engine and generator
are located in the compartment on the left side of the
coach. They are spin-on types, and are easily replaced.
Use caution to avoid fuel spillage.
Inspect and maintain the fuel system in accordance
with the Maintenance Schedule. Check fuel lines for
signs of leakage, damage or deterioration. Tighten
clamps if they are loose. Replace filters in the fuel line
and the evaporative control system at the recom-
mended intervals.
Air Cleaner Element Replacement
Paper Element -
1. Remove the air cleaner cover.
2. Remove the element.
3. Install a new element in the air cleaner with
either end up.
4. Install the air cleaner cover. Do not overtighten
wing nut.
Polywrap Element -
1. Remove the air cleaner cover.
.2. Remove the element.
3. Remove the polywrap band from the paper ele-
ment and discard the element.
4. Clean the bottom section of the air cleaner and
inspect the cover seal for tears or cracks.
Replace the seal if damaged.
5. Inspect the band for tears and replace if
damaged.
6.· If the band is serviceable, wash it in kerosene
or mineral spirits and squeeze out the excess
solvent.
NOTE: Never use a hot degreaser or any solvent .
containing acetone:or similar solvent; also, never
shake, swing or wring the .ehimen,t .to remove ex-
cess solvent as thlsmYl\f'teafllliil'pblyurethline
'material. Instead, "squeeze" the excess solvent
from the element: Squeezing will avoid'damag-
Ing the element materiil!':' . ,'" ...... . """
, .. .
7. Dip the band into light engine'oil
aha
~qu~eze
out the excess oil.
8. Install the band around the outer surface of the
new paper element.
.
. 9. Install the element in the bottom section of the
air cleaner with either end up.-
10. Install the air cleaner cover. Do not over-torque
Fuel Fifter
the wing nut(s).
'
.
54
NOTE: POLYURETHANE BAND MUST
WRAP OVER BOTH END SEALS OF
PAPER ELEMENT AS SHOWN.
1111"1' 1 ' 1 11
~~~~F2~rt:
PAPER FILTER PORTION
~
OF POLYWRAP AIR
CLEANER ELEMENT
ii, .
) : . "'., ~ .
ELEMENT
AS SHOWN.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents