Fleetwood Bounder 1987 Owner's Manual page 22

.
,
The headlight circuit is protected by a circuit
breaker in the light switch. An overload on the
breaker will cause the lights to "flicker" on and
off. If this condition develops, have your
headlight wiring checked immediately.
4. 2-Speed Windshield Wiper/Washer with
Delay-Turn inner knob clockwise for wiper ac-
tion. The wiper blades are mounted on "articu-
lated" arms that allow the blades to follow a
wiping path as wide as possible.
OFF-No wiper action.
1st notch -Wiper delay ON. Turn outer knob
clockwise for longer delay between wiper
strokes.
2nd notch-Slow wiping action.
3rd notch - Fast wiping action.
To WASH, press outer knob, then release. One
press of washer knob cycles wipers once. The
washer nozzles are located on the wiper arms
close to the wiper blades. They move with the
blades and provide continuous washer coverage.
NOTE: Windshield wipers are controlled by separate
motors, and do not necessarily wipe in synchroniza-
tion. When wipers are turned OFF, one or the other
wiper blade may lag behind before stopping. On
DELAY setting, wiper blades will not necessarily
operate in sync.
5. Auxiliary Start Switch -The Auxiliary Start
System permits using the auxiliary battery (see
Electrical System) to start the motor home
engine if the vehicle.battery is discharged. To
use the Auxiliary Start System:
*
Be sure the vehicle is stopped, shift to "P"
(PARK) and apply the parking brake.
* Press and hold the Auxiliary Start switch on
the instrument panel.
*
Start enlline with ignition switch.
• Release' AU1<iliary Start switch.
The AuxiliarY'Start System ha's' no effect on the
'vehicle except to aid in starting the motor home
engine. If the vehicle alternator is operating pro-
perly, the batteries will be recharged while driv-
. in
g .
(see
EJ!~~{l~~I,S~~1!ij~~~i'\\;,i'rJ)l'
.•
6. Instrumerjl t?1}l~~er\'!"!IiI' ·Wf·:~"'!!··;'·(·'·-.'
-4·, '," .:' _'_ .• ; - '", - .
. 7. Radio/TapePlayCl' .
/ . ' '. " ' . 0 ,
::.;,'''..--
S., Monitot ,ea.!)el
""
\
9.
Tran~mission
Selector-Pull transmission. lever
toward you and move' to desired position. Please
refer to the Chassis Operator's Manual for more
details on trans'mission operation. . .
10. Generator Remote Start/Stop Switch
11. .
CigarettClLighter
14
12. Heater/Air Conditioner Controls -The cockpit
Heater/Air Conditioner controls are located on
the lower right instrument panel. These controls
operate the heating and air conditioning systems
for the driver/cockpit area only.
Cool/Heat Lever-Push this lever to the left
or right for cooling/heating.
Function Selector Buttons
OFF-No heating or cooling, but fan runs
at low speed for continuous circulation of
outside air through the instrument panel
outlets.
MAX A/C-Air conditioner compressor is
on, inside air is recirculated through the
system for maximum cooling.
A/C -Air conditioner 'compressor is on,
outside air is circulated through instrument
panel outlets.
VENT -A/C compressor is off, outside air
is circulated through the instrument panel
outlets,
HEAT-AiC compressor is off, outside air
is circulated through the heating system,
and distributed to floor outlets.
Heated air is circulated to defroster outlets.
Fan Switch - Sets fan speed to any of 4
speeds. The fan switch does not affect the
fan if the OFF function button is pressed.
13. Ignition SwitCh-Operation of the ignition
switch is shown below.
ACC
OFF
ON START
14. 6-Position Tilt Steeting Wheel-PUll the tilt lever
. towards the steering wheel to release. Release
lever at desired tilt angle.
. 15 ..
Ha~~rgvya.rl)i!!g,Flasher-lii.ashes}x(>nt
Ii <
rear
fo'r emergency
p~lrklng.Press
center button to
engage,' pull oute'r',collar to tur.n off ..
, ,