City Model - Mercedes-Benz 2013 S-Class Operator's Manual

Navigation
190
Geo-coordinate display
Geo-coordinate display active
Current height above average sea level,
:
rounded
Current vehicle position: latitude
;
coordinates
Current vehicle position: longitude
=
coordinates
Number of GPS satellites currently being
?
used
There must be sufficient GPS reception for all
displays to be shown. If this is not the case,
the display will be grayed out. Height
display : may vary from the actual value,
because the navigation system uses the GPS
signals for the calculation.
While scrolling the map (
see the geo-coordinates of the crosshair
position. Height display : and number of
satellites used ? are not displayed.
"None" menu option
Display switched off
Current map orientation
:
i
During the "Move map" function you can
see additional information depending on
the position of the crosshair, such as a road
name, if the digital map supports this data.
Switching the topographical map on/
off
The topographical map uses different colors
to depict elevation. The color key generally
reflects the topography's dominant
vegetation or the ground's perceived color
when seen from the air, for example:
R
R
R
X
X
X
Switching the city model on/off
page 187), you will
Y
When the city model is switched on, the map
shows buildings as 3D models.
i
X
X
X
green for lowland
yellow or brown for hills
gray or white for mountains
To show the menu: press W the COMAND
controller.
Select Navi in the main function bar by
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
Select Topographical Map
with W.
Depending on the previous state, switch
the option on O or off ª.
The city model is only shown in the "3D
map" map orientation.
It is available for map scales 50 m and
100 m.
The data required for displaying buildings
is not available for all cities.
To show the menu: press W the COMAND
controller.
Select Navi in the main function bar by
sliding ZV and turning cVd the COMAND
controller and press W to confirm.
Select City (3D) and press W to confirm.
Depending on the previous state, switch
the option on O or off ª.
and confirm