Winegard RoadTrip Mission Manual page 7

If a switch other than SW64 appears, or you have an 'X' in one of the boxes below the satellites,
repeat Check Switch Steps.
5. your system is now set up to toggle between satellites. It will automatically move to the correct
satellite when a channel is selected with your remote control.
NOTE: Once these steps are completed, you won't have to perform this test again, unless
Check Switch was performed on another satellite dish, such as a home dish.
Toggle: The RoadTrip Mission is an automatic single satellite antenna capable of viewing
only one satellite at a time. To provide all of the programming for multiple satellite
packages, the RoadTrip Mission will move between each of the satellites as required
by the Primary receiver. This means that the Primary receiver will function very much
like a home satellite antenna in that it will seamlessly move from primary to alternate
satellites as required by the receiver. However, the secondary receiver will only provide
programming from the satellite that the Primary receiver is on or was last using.
Note: The RoadTrip Mission antenna is designed to be maintenance free. However, it is
a good idea to clean the dome from time to time with a soft cloth, water and dish soap.
Warning: Painting the RoadTrip Mission dome voids the warranty, degrades signal
strength and may cause damage to the antenna.
To order receivers or programming call (866) 609-9374.
DIRECTV must be set to the "two" satellite, oval dish setting. Refer to your receiver manual.
DISH Network receivers must have the check switch set to "SW64". See page 6.
7