Parts Included; Tools Needed For Unpacking & Installation; Unpacking The Unit - Winegard RoadTrip Mission Manual

Parts Included • Tools Needed • Unpacking the Unit

PARTS INCLUDED:

1 RoadTrip Mission Automatic Satellite TV Antenna
1 Hardware bag containing:
2 Cable Ties
Wall Plate
On/Off Power Switch
2 Insulated Terminals
Flag Terminal
2 Cable Clamps
Cable Entry Plate
16 Mounting Screws
1 30' RG6 Coax
1 25' Power Cable
TOOLS NEEDED FOR UNPACKING & INSTALLATION:
Level
Drill with 3/4" bit
1-1/4" hole saw (if mounting switch in wall)
Phillips screw driver #2

UNPACKING THE UNIT:

. Open box and remove packing material.
1
If using knife to open
!
carton, BE CAREFUL.
Do not cut the dome on
the unit.
For Winegard Warranty Information:
Attn: Technical Services
Winegard Company
3111 Kirkwood St.
Burlington, IA 52601
Ph: 800-788-4417
Fax: 319-758-5854
Disclaimer:
Although every effort has been made to insure the information in this manual is correct and complete, no
company shall be held liable for any errors or omissions in this manual. Changes and technological advances are
continuously being made in the satellite market. Information provided in this manual was accurate at the time of
printing. If the RoadTrip® Mission ™ does not function as expected, please contact Winegard Company at (800)
788-4417 or visit our website at www.winegard.com.
Trademarks:
Winegard and RoadTrip are registered trademarks of Winegard Company. Mission is a trademark of Winegard
Company. DISH Network is a registered trademark of EchoStar Satellite L.L.C. DIRECTV is a registered
trademark of DIRECTV, Inc., a unit of Hughes Electronics Corp. Bell TV is a trademark of Bell Canada, Inc. All
trademarks contained in this manual are property of their respective owners. Reference made to products or
services provided by companies, other than Winegard Company, does not represent any endorsement of those
products or services.
7/16" Open end wrench
Mounting Hardware & Sealant (consult vehicle
manufacturer)
2. Lift unit out of box vertically. Do not turn box
and "roll" out, or turn upside down to remove.
USE 2 PEOPLE
when removing the unit
from the carton.
!
DO NOT PAINT DOME!
Painting dome will cause
signal degradation and
will void your warranty.
2