Shipping Your Hp Workstation - Creative Sound Blaster X-Fi Installation Manual

If the application does not start, double-click the setup.exe file in the Installation and
Application CD.
NOTE:
12. After you have installed the software, see your speaker manufacturer documentation for
instructions on how to connect the speaker to your system.
NOTE:
for diagnostic beeps and does not play any other sound. The rear audio connectors on the system
board are also disabled when the X-Fi sound card is installed. Use the audio output from the X-Fi
sound card for audio connection to the external audio device.

Shipping your HP workstation

When shipping your HP xw6000, xw8000, or xw9000 series workstation, install the shipping support
arm.
For standard desktop use, the shipping support is not required.
NOTE: Your workstation might look different than the one shown graphics below.
Adding support arm to card support assembly (HP xw8000/xw9000 series
workstations only)
1. Add a new arm and insert it from bottom of the housing. The new arm must support the X-Fi card,
so choose the correct location. Your workstation might have other support arms already installed
over other slots (not shown in picture).
2. Push the arm into the housing (1). Slide the arm back to lock it in place (2).
Figure 3
6 Creative Sound Blaster X-Fi card installation
To check the availability of newer drivers for your workstation, go to http://www.hp.com.
When the sound card is installed in the system, the internal chassis speaker only functions
Preparing the support arm
ENWW