JVC LVT2088-001B Instruction Manual page 24

Category Menu items
FADER* 5
Fader
BALANCE * 6
Balance
VOL ADJUST
Volume adjust
SUB.W FREQ
Subwoofer cutoff
frequency
SUB.W LEVEL
Subwoofer level
BEEP
Keypress tone
AMP GAIN
Amplifier gain
control
AM * 7
AM station
EXT IN * 8, * 9
External input
AUX IN * 10
Auxiliary input
*
5 If you are using a two-speaker system, set the fader level to "00."
*
6 This adjustment will not aff ect the subwoofer output.
* Displayed only when any source other than "AM" is selected.
7
*
8 Displayed only when any source other than "EXT INPUT" is selected.
*
9 Not required for SIRIUS/XM tuners and Bluetooth.
*
10 Displayed only when any source other than "AUX IN" is selected.
24
Selectable settings, [reference page]
FADER R12 Adjust the front and rear speaker output balance.
— FADER F12: [Initial: 00]
BALANCE L12 Adjust the left and right speaker output balance.
— BALANCE R12: [Initial: 00]
VOL ADJ –10 Preset the volume adjustment level of each source (except
— VOL ADJ +10: FM, BT PHONE and BT AUDIO), compared to the FM volume
[Initial: VOL ADJ 00] level. The volume level will automatically increase or
decrease when you change the source.
• Before making an adjustment, select the source you want
to adjust.
• "VOL ADJ FIX" appears on the display if "FM", "BT PHONE",
or "BT AUDIO" is selected as the source.
• LOW: Frequencies lower than 72 Hz are sent to the subwoofer.
• MID: Frequencies lower than 111 Hz are sent to the subwoofer.
• HIGH : Frequencies lower than 157 Hz are sent to the subwoofer.
SUB.W 00 Adjust the subwoofer output level.
— SUB.W 08: [Initial: SUB.W 04]
• BEEP OFF: Deactivates the keypress tone.
• BEEP ON: Activates the keypress tone.
• LOW POWER: VOLUME 00 – VOLUME 30 (Select if the maximum power
of each speaker is less than 50 W to prevent damaging the
speaker.)
• HIGH POWER: VOLUME 00 – VOLUME 50
• OFF: Deactivates the built-in amplifier.
If you change the "AMP GAIN" setting from "HIGH POWER" to "LOW
POWER" while the volume level is set higher than "VOLUME 30," the unit
automatically changes the volume level to "VOLUME 30."
• AM OFF: Disable "AM" in source selection.
• AM ON: Enable "AM" in source selection.
• EXT OFF: Disable "EXT INPUT" in source selection.
• EXT ON: Enable "EXT INPUT" in source selection.
• AUX OFF: Disable "AUX IN" in source selection.
• AUX ON: Enable "AUX IN" in source selection.