Source Switching; M-Controller I/O Pin Configuration And Function - Daewoo DTA-20 T1 Service Manual

5-3 Source switching

The TDA936x has only one external video input, the external video switching circuit made with Q504,
Q505, Q507, Q508 and Q509 allows 2 external video signal inputs. The switching command can be
either the SCART1 slow switching pin 8 or the µ-Controller pin 8 when the software takes control of
the video source. The µ-Controller pin 8 is automatically configured by the controlling software ( See
table below ). This pin is also capable of detecting the 3 Status ( 0, 1A, 1B ) described in SCART
specifications for automatic format switching ( chassis CP785 only ).
TV mode
RF auto
RF Forced
AV 1 Auto 4:3
AV 1 Auto 16:9
AV 1 forced
AV 2
SVHS
The controlling software via I2C bus selects the signal source :
- Video signal from tuner ( Pin 40 ).
- External video ( SCART 1 or 2 ) depending on Q508 base level.
- External SVHS from SCART 2.
The sound source switching is done in the MSP3415D ( I601 ), by the µ-Controller via I2C bus.
Fast R, G, B insertion : The external R, G, B insertion needs a fast switching and cannot be controlled
by the software ( instruction cycle of 1µ sec ). The fast switching pin 16 of SCART 1 is directly
connected to the TV processor pin 45 ( Fast blanking input ). The display is synchronised with the
selected video source, i.e. to get stable R, G, B inserted signal they must be synchronised with the
selected video source. The controlling software only enable or disable ( AV2, SVHS, or Forced RF
source selected ) fast blanking.
5-4 µ-Controller I/O pin configuration and function
The I/O pins of the µ-Controller can be configured in many way. All port functions can be individually
programmed by use of the SFR registers.
Each I/O port pin can be individually programmed in these configurations :
Open drain
In this mode, the port can function as in and output. It requires an external pull-up resistor. The
maximum allowable supply voltage for this pull up resistor is +5V.
So in this mode it is possible to interface a 5 Volt environment like I2C while the µ-Controller has a 3.3
Volt supply.
Push-Pull
The push pull mode can be used for output only. Both sinking and sourcing is active, which leads to
sleep slopes. The levels are 0 and Vddp, the supply voltage 3.3Volts.
µ-Controller pin 8 Status
Input - High Impedance
Input - High Impedance
Input - High Impedance
Input - High Impedance
Output - Push Pull
Output - Push Pull
Output - Push Pull
- 39 -
Service manual CP 385 / CP785
Level
< 1V
not defined
> 2.0 V
1 V < x < 2.0 V
Max. 3.3V
< 0.2 V
< 0.2 V