Table of Contents
Advertisement
EXTERIOR/INTERIOR TRIM
19.Rear Quarter Trim
A: REMOVAL
1. SEDAN
1) Remove rear mole (A).
2) Remove rear shelf trim. <Ref. to EI-45, REMOV-
AL, Rear Shelf Trim.>
3) Remove side sill rear upper cover. <Ref. to EI-
39, REMOVAL, Lower Inner Trim.>
4) Remove rear pillar lower trim (B).
5) Remove rear pillar upper trim (C).
( A )
2. WAGON
1) Remove side sill rear upper cover. <Ref. to EI-
39, REMOVAL, Lower Inner Trim.>
2) Remove luggage floor mat. <Ref. to EI-49, RE-
MOVAL, Luggage Floor Mat.>
3) Remove rear skirt trim (A).
4) Remove rear quarter lower trim mounting volts,
screws and clips, then remove the trim (B).
5) Remove rear mole (C).
6) Remove rear quarter upper trim mounting screw,
then remove the trim (D).
REAR QUARTER TRIM
( C )
( B )
EI-00197
EI-40
7) Remove rear rail trim (E).
( D )
( C )
( B )
( 1 )
:
(1) Hook pawl
B: INSTALLATION
Install in the reverse order of removal.
CAUTION:
Be sure to securely hook pawls of inner trim
panel to body flange.
NOTE:
When installing rear quarter upper trim, be sure to
set rear mole as shown in the figure.
( 1 )
( 3 )
( 5 )
(1) Outside
(2) Inside
(3) Weatherstrip
(4) Molding
(5) Body
(6) Trim
( E )
( A )
EI-00198
( 2 )
( 4 )
( 6 )
EI-00195
Advertisement
Table of Contents
