Co Alarm Response Time - Kidde 10SCO User Manual

To activate the battery carrier tamper resist feature, remove the unit from the trim
and locate the small cut-out in the middle of the product label on the back of the unit.
With a small screwdriver, or similar tool, slide the switch towards the top of the label.
(see Figure 6) The tamper resist feature is now active and the battery carrier cannot
be opened until the tamper resist feature is deactivated.
NOTE: Before activating the battery carrier tamper resist feature, make sure a fresh
battery is installed in the unit and that the battery carrier is properly closed. If the
battery carrier tamper resist feature is activated while the battery carrier is open, the
battery carrier will not close and the unit will be inoperable.
To deactivate the battery carrier tamper resist, in order to change the smoke alarm
battery, remove the unit from the trim plate (see Smoke Alarm Tamper Resist
Feature if activated), and locate
Using a screwdriver, or similar tool, slide the switch towards the bottom of the
product label. The battery carrier can now be opened and the battery changed.

CO Alarm Response Time

Never restart the source of a CO problem until it has been fixed. NEVER
IGNORE THE ALARM!
The CO sensor meets the alarm response time requirements of EN50291-1:2010
Standard alarm times are as follows:
Parts per million (PPM) of CO
50
100
300
This carbon monoxide alarm is designed to detect carbon monoxide gas from
ANY source of combustion. It is NOT designed to detect any other gas.
It can be possible to arrange for a CO inspection of your home or property, but som
inspectors may charge for this service.
or user of this product for any repair or dispatch calls related to the alarm sounding
so it is advisable to inquire about fees prior to having such a service performed.
the small cut-out in the middle of the product label.
60 - 90 minutes
10 - 40 minutes
Must alarm in less than 3 minutes
Kidde
Time until Alarm
will not pay for or reimburse the owner
e