Pioneer DVR-54HX-S Operating Instructions And Owner's Manual page 149

The Initial Setup menu
Setting
Audio Output
This setting is not available when a DVI device is connected
Video Priority Mode HDMI •
Options
On Screen Display
Front Panel Display On •
Remote Control
Mode
Options Explanation
Auto •
Dolby Digital, MPEG and DTS sources are output as
a bitstream signal. However, depending on the
Audio Out setting, number of audio channels, and
the HDMI-connected device, Linear PCM audio may
be output.
PCM
All audio signals are converted to Linear PCM
(except DTS).
Bitstream Priority Select if the connected device is compatible with bit-
stream audio.
Select for high quality picture output on a connected
HDMI display. However, on this setting the YNR and
Detail picture quality settings are not effective for
analog video, and component video will be set to
interlaced.
Component Select if you want the YNR and Detail picture quality
settings to be effective for both HDMI and analog
video output, or if Component Video Out is set to
Progressive while an HDMI display is connected
(page 141).
When watching video on an HDMI display, use the
HDMI setting.
On • The recorder displays operation displays (Stop, Play,
etc.) on-screen.
Off
Switches off the on-screen operation displays.
The time is shown in the front panel display when the
recorder is in standby.
Off The front panel display is switched off in standby
(although it still lights dimly when setting a timer
recording).
Recorder 1–3 If you are using more than one recorder in the same
(default: Recorder 1) room, set them to different IDs. This setting sets the
recorder ID; to change the remote controller ID,
press and hold RETURN/EXIT then press 1, 2 or 3 to
set. The remote will only control a recorder with the
same ID.
.
16
149
En