LIMIT THERMOSTAT - VPR, VPS
FIG. 10-1 LIMIT THERMOSTAT
Location:
The limit thermostat is located inside the hood on
the right side of the tank lid.
Test Procedures:
1.
Disconnect the brewer from the power source.
2.
Disconnect the blue/black and black wires from
the limit thermostat.
3.
Check for continuity across the limit thermostat
terminals with an ohmmeter.
If continuity is present as described, the limit thermostat
is operating properly.
If continuity is not present as described, replace the
limit thermostat.
Removal and Replacement:
1.
Remove all wires from limit thermostat termi-
nals.
2.
Carefully slide the limit thermostat out from under
the retaining clip and remove limit thermostat.
3.
Carefully slide the new limit thermostat into the
retaining clip.
4.
Refer to wiring diagram when reconnecting the
wires.
FIG. 10-2 LIMIT THERMOSTAT TERMINALS
Page 10
41667 102708