Cub Cadet RZT L Series Operator's Manual page 11

Lower Deck Discharge Chute Deflector
WARNING!
Never operate the mower deck
without the chute deflector installed and in the
down position.
The discharge chute deflector must be installed before operating
the mower.
NOTE: For models with a 54" Deck skip ahead to step 4.
1. Remove the keys that are attached with a zip tie to the
chute bracket.
2. Remove the flange lock nuts from the deck. Do not remove
the push nuts or carriage bolts, leaving them in place will
aid in installing the chute. See Figure 3-6.
50" Deck
Shown
Flange Lock Nuts
Push Nuts
Figure 3-6
3. Install the discharge chute deflector using the carriage
bolts, push nuts and flange lock nuts as shown in 4. On
models with a 54" Deck the chute is shipped attached and
with a stop bracket holding the chute upright. The stop
bracket must be removed prior to operating the tractor
and securely tighten the hardware.
50" Deck
Shown
Discharge
Chute
Deflector
Push Nuts
Figure 3-7
4.
5.
Carriage Bolts
Adjusting the Seat
To adjust the position of the seat, pull up and hold the seat
adjustment lever. Slide the seat forward or rearward to the desired
position; then release the adjustment lever. Make sure seat is
locked into position before operating the tractor. See Figure 3-9.
Flange Lock Nuts
Carriage Bolts
On models with a 54" Deck the chute is shipped attached
and with a stop bracket holding the chute upright. The
stop bracket must be removed prior to operating the
tractor.
Holding the chute deflector fully upward, remove the stop
bracket by grasping it and rotating it clockwise. Lower the
chute deflector Figure 3-8.
Figure 3-8
Figure 3-9
S
ection
2 — A & S -U
SSembly et p
11