Table of Contents
Advertisement
Playing the current tune repeatedly
You can play the current tune repeatedly
(Repeat Play).
1
Press MODE to enter the
functions mode while playing a
tune you want to hear over again
on a cassette.
2
Press RPT (repeat), while still in
the functions mode, so that
"REPEAT" appears on the
display.
When the tune has been played, the tape is
automatically rewound to the beginning of that
tune and the same tune will be played again.
To cancel Repeat Play, repeat steps 1 and 2
again so that the RPT indicator goes off.
Note:
In the following cases, Blank Skip and Repeat Play
may not operate correctly:
– Tapes with tunes having long pianissimo passages
(very quiet parts) or non-recorded portions during
tunes.
– Tapes with short non-recorded sections.
– Tapes with high level noise or humming between
tunes.
– Tapes with tunes recorded at low recording levels.
12
Prohibiting cassette ejection
You can prohibit cassette ejection and lock a
cassette in the cassette compartment.
While pressing TAPE 23, press and
hold 0 (eject) for more than 2 seconds.
"NO EJECT" flashes on the display for about
5 seconds, and the cassette is locked and cannot
be ejected.
RPT indicator
To cancel the prohibition and unlock the
cassette
While pressing TAPE 23, press and hold
0 (eject) again for more than 2 seconds.
"EJECT OK" flashes on the display for about
5 seconds, and the cassette is unlocked.
Note:
If you press 0 (eject) while cassette ejection is
prohibited, the cassette will not be ejected.
Advertisement
Table of Contents
