Remote Control Functions - Twin-Star International 18EF020GAA Operating Manual

Vent free fireplace with heater

Hide thumbs

Table Of Contents

Table of Contents

Available languages

REMOTE CONTROL FEATURES WORK SEAMLESSLY WITH CONTROL PANEL FUNCTIONS

3 BUTTONS REMOTE

23EF020GRA, 28EF020GRA & 33EF020GRA

MODELS ONLY

NOTE: The insert Main Power Switch must be switched

ON in order for the Remote Control to function.

POWER

The Power button will put the insert in a standby

mode. This will turn off all functions at once but

will hold the settings in memory. By pressing the

button again the unit will turn on at the same settings.

FLAME

Each time the flame button is pressed, the intensity

of the flame decreases. There are six brightness

levels you can cycle through including the OFF setting.

HEATER

This button will turn the power to the heater and

blower ON and OFF. The blower starts to work and

blow hot air when turn on this button. The rotary switch

(TEMPERATURE) controls the thermostat feature

to help regulate your room's temperature accordingly.

NOTE: This remote control uses 1 CR2032 Lithium lon button cell battery (Included). Never dispose of

batteries in ﬁre, except under conditions of controlled incineration. (Failure to observe this precaution may

result in an explosion.)

NOTE: This equipment has been tested and found to comply with the limits for Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the instructions, may cause harmful

interference to radio or television reception, which can be determined by turning the equipment off and on,

the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired operation.

Modifications not approved by the party responsible for compliance could void user's authority to

operate the equipment.

This Class B digital apparatus complies with Canadian ICES-003.