Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Russound ST1 smart tuner
- Page 1 Smart Tuner Installation Manual...
-
Page 2: Safety Instructions
Cet appareil numérique de la classe B est conforme à la norme NMB-003 with wet or damp hands. If water or any other liquid enters appliance and cart combination to overturn. du Canada. the appliance cabinet, take it to qualifi ed service personnel for inspection. Russound ST1 Installation Manual... -
Page 3: Safety-Outdoor Antenna Connection
For complete guidelines on antenna grounding procedures, please consult the National Electrical Code, Section 810, ANSI/NFPA No. 70-1984. Antenna Lead-In Wire Grounding Conductors Ground Clamps Electric Service Equipment Power Service Grounding Electrode System Russound ST1 Installation Manual... -
Page 4: Table Of Contents
The ST1 features RDS (Radio Data System) reception that will display metadata the broadcasting station has encoded in the broadcast signal such as station name, and song information. All of this is visible on Russound C-Series system user interfaces which make this data available through the RNET communication protocol for third party control systems. -
Page 5: Front And Back Panel Illustrations
FRONT AND REAR PANEL ST1 Front Panel Power Switch / LED RNET Link Firmware Update Source ID Switches Audio Outputs AM/FM Antenna AC Power Inlet Connections ST1 Rear Panel Russound ST1 Installation Manual... -
Page 6: Front And Back Panel Features
The ST1 comes with both an AM loop antenna and an FM Antenna terminated Russound devices with an RNET Link are connected in series using CAT5 patch with a press-on coaxial fi tting. Insert each lead of the AM loop antenna into the cables terminated with RJ45 ends in the T568A confi guration. -
Page 7: Installation Options
To avoid overheating situations, make sure the top panel ventilation holes are not blocked. Single unit rack mounting option Dual unit rack mounting option Russound ST1 Installation Manual... -
Page 8: Connections With C-Series Contorllers
Source ID switch setting made. Next connect the RNET Link cable from the ST1 to the C-Series controller or to another RNET link port that exists in the Russound system such as that found To AM/FM Antenna 75 to 300... - Page 9 CONNECTIONS WITH C-SERIES CONTROLLERS FM antenna AM loop antenna FM antenna AM loop antenna RCA Audio Cable RNET Link (CAT5) MCA-C5 Russound ST1 Installation Manual...
-
Page 10: Operation
ST1 can be selected as a source. It will behave identically to the tuner which is built into the C-Series controller. For specifi c details, please refer to the user manual for the C-Series controller and the manual for the particular user interface chosen. Russound ST1 Installation Manual... -
Page 11: Warranty / Technical Specifi Cations
In these cases, repairs will be made on the basis of the retail value of the parts and labor. To return for repairs, the unit must be shipped to Russound at the owner’s expense, along with a note explaining the nature of service required. Be sure to pack the unit in a corrugated container with at least three (3) inches of resilient material to protect the unit from damage in transit. - Page 12 Russound, Inc. All trademarks are the property of their respective owners. Specifi cations are subject to 5 Forbes Road, Newmarket, NH 03857 change without notice. Russound is not responsible for typographical errors or omissions. tel 603.659.5170 • fax 603.659.5388 email: tech@russound.com www.russound.com...