Setting The Ta Volume Level; Automatic Clock Adjustment - JVC F540R Instructions Manual

Changing the display mode while listening to an FM
station
You can change the initial indication on the display to station frequency, station name (PS), or
clock time while listening to an FM RDS station.
• See also "Changing the general settings" on page 23.
1. Press and hold SEL (select) for more than 2 seconds to call up the general settings mode.
2. Select "DISPMODE" with
3. Use the +/– button to select the desired indication from the following: PS name (station
name), FREQ (station frequency), and CLOCK (clock time).
Note:
By pressing DISP, you can also change the display while listening to an FM RDS station.
Each time you press the button, the display changes to show the following.
Station name
* The display returns to the initially preset mode after a short while.

Setting the TA volume level

You can preset the volume level for TA Standby Reception. When a traffic programme is
received, the volume level automatically changes to the preset level.
• See also "Changing the general settings" on page 23.
1. Press and hold SEL (select) for more than 2 seconds to call up the general settings mode.
2. Select "TA VOL" with
3. Set to the desired volume level with the +/– button.

Automatic clock adjustment

When shipped from the factory, the clock built in this unit is set to be readjusted automatically
using the CT (Clock Time) data in the RDS signal.
If you do not want to use automatic clock adjustment, follow the procedure below.
• See also "Changing the general settings" on page 23.
1. Press and hold SEL (select) for more than 2 seconds to call up the general settings mode.
2. Select "AUTO ADJ" with
3. Select "ADJ OFF" by pressing the – button.
Now automatic clock adjustment is cancelled.
To reactivate clock adjustment, repeat the same procedure and select "ADJ ON" in step 3
by pressing the + button.
Note:
It takes about 2 minutes to adjust the time using the CT data. So, you must tune to the station for more
than 2 minutes continuously; otherwise, the clock time will not be adjusted.
¢ or 4
Frequency
PTY (Programme type)
¢ or 4
.
¢ or 4
.
.
Clock time
15